Recording; Recording Mute; Erasing A Tape - Pioneer CT-W205R Operating Instructions Manual

I RECORDING
I RECORDING (Deck II only)
2 3
ro -- el
r 11,.I E IBI.,
,I Z I.. - n_
76
4
1. Load a tape for recording in Deck II.
2. Set the DOLBY NR switch.
3. Set the REV MODE switch.
• To record on one side only, set the switch to the 7
position,To recordon both sides,set the switch to the
position,
4. Press the recording (o) button.
5. Prepare the audio source from which you wish to
record. Turn on the stereo amplifier and prepare it
for playback of the desired audio source.
6, Adjust the recording level. For details, see "ADJUST-
ING THE RECORDING LEVEL" below.
7. Press the playback (ib or <1) button or the pause (11)
button to begin recording.
• When recordingon both sides, press the )- button, If the
<1 buttonis pressed, recording will stop afteronly oneside
is recorded.
To stop recording temporarily
Press the pause (11)button.
• To resume recording, ehher press the pause (11)button again, or
press the p_syback (IP or <l) button.
To Stop Recording
Press the stop (n) button.
Erasure prevention
tabs
The recording (o) button does not work when the erasure prevention
tabs of the loaded cassette tape have been broken off (See page 5).
Do not press the recording (o) button with unreasonable force. When
recording on both sides, make sure that both tabs are intact.
ADJUSTING THE RECORDING LEVEL
The adjustment of the recording level is the most important factor in
achieving good recording results. A high level provides a good signak
to-nolse ratio and dynamlc range, but an excessively high level dis-
torts the sound. If the level is set too low for fear of sound distortion,
irritating tape hiss will mar the recording. The characteristics of tapes
differ depending on the manufacturer and the type of tape. Set the
REC LEVEL control so that the level meter's "-3 dB" indicator lights
steadily most of the time. No harm will be done if the "0 dB" indica-
tor lights momentarily at beaks. When recording without Dolby NR,
set the REC LEVEL control so that the "-3 dB • indicator lights, and
the "0 dB" indicator lights occasionally at beaks.
NOTES:
• The optimal recording level may differ somewhat depending on
the audio source and type of tape used. In order to obtain the
best possible results, set the recording level after actual testing.
Listen to your recordings, and adjust the level as necessary.
• The level meter may react differently during recording and play-
back of the same tape. This is due to differences in tape sensitiv-
ity, and creates no problem.
I RECORDING MUTE
Use this function to create the 4.5-second blanks needed for proper
operation of the music search function.
• Press the recording mute (0) button during recording and the
deck will create a blank space by recording a section which
contains no signal for approximately 4.5 seconds. The deck will
then enter recording standby mode.
• To create a blank which is more than 4,5 seconds long, hold the
button down for the desired length of time. When the button is
released, the deck will enter recording standby mode.
• Toreaumerecordlng. pressthepaoae(u)buttonortheptayback
(_ or ,11)button.
I ERASING A TAPE I
To erase the recorded contents of a tape, load the tape in DECK II
and follow the procedure below.
2
31
1. Set the REC LEVEL €ontrol to the MIN position.
2. Press tho recording (o} button.
3. Prsos the plsyba©k (1_ or <) button or the pause (11)
button.
12
<RRB1169>
En