Advertisement
RECORDING (TAPE COPYING)
To Stop Copying
Press the stop (MI) button of either deck. Both decks will stop.
NOTES:
/f a nearby television set is on while high speed copying is being per-
formed, a high pitched interference sound may be heard on the tape.
In this case, either use the normal speed copying function, or turn off
the television.
|
.
The tape in Deck If will be recorded with the same Dolby NR charac-
teristics as the tape in Deck | regardless of the setting of the DOLBY
NR switch. For example, if the original tape was recorded with Dolby
C-type NR, the copy will also have Dolby C-type NR.
During high speed copying, none of the operation buttons will function
except for the stop (1 } button.
During normal speed copying, the recording mute {OQ } and pause
(88) buttons of Deck Il also function.
Tape copying stops when either of the two tapes reach the end.
Therefore it is advisable to use tapes of the same length.
The sound quality of the copied tape will be somewhat less than that
of the original. Therefore when making more than one copy, always
record from the original tape (do not make a copy of a copy).
When making tape copies, the recording level does not have to be
adjusted.
RECORDING AND PLAYBACK USING AN AUDIO TIMER
UNATTENDED
RECORDING
(Deck II only)
WAKE-UP PLAYBACK
(Deck I or Deck II)
Oo Pwn
Load a tape for recording in Deck Il.
@ Timer recording always begins in the forward direction. .Make
sure that the tape is properly rewound.
Set the DOLBY NR switch.
Set the REV MODE switch.
Press the recording ( e ) button.
Prepare the audio source.
® Set the amplifier
input selector
to tuner,
then
tune
in the
desired station.
Adjust the recording level.
Set the audio timer.
@ When the timer is set, it will turn off the power of all connect-
ed components.
Set the TIMER switch to the REC position.
@ At the preset time, the power will be turned on, and recording
will begin automatically.
NOTES:
Timer recording will not work if the erasure prevention tabs of the
tape loaded in Deck If have been removed.
Operations depend on the type of audio timer used: Be sure to consult
the operating instructions of the audio timer you actually use.
When not performing
timer operations,
set the TIMER switch
to
the OFF position. Otherwise,
recording might begin unexpectedly
when the power is turned on.
Turn down the volume of the amplifier if you do not wish to listen
to the program while it is being recorded.
1.
Load the tape(s) for playback.
@ Timer playback always begins in the forward direction. Make
sure that the tape(s) are properly rewound.
2.
Set the DOLBY NR switch.
3.
Set the REV MODE switch.
4.
Set the stereo amplifier for tape playback.
@ Adjust the volume level by playing back a portion the tape.
5.
Rewind the tape to the position where playback
1s
to start.
|
6.
Set the audio timer.
@ When the timer is set, it will turn off the power of all connect-
ed components.
7.
Set the TIMER switch to the PLAY position.
@ At the time set on the audio timer, the power will be turned
on and playback will begin automatically.
NOTES:
®
Operations depend on the type of audio timer used: Be sure to consult
the operating instructions of the audio timer you actually use.
@
When tapes are inserted in both Deck | and Deck Il, relay playback
from Deck | to Deck I/ will be performed when the power comes on.
@
The blank skip function will operate during timer playback (see page
8).
.
®@®
When not performing timer operations, set the TIMER switch to the
11
<RRB1i103>
En
Advertisement
