Setting the Headphone Level
SETUP
You can set the volume when using headphones.
1
Press SETUP.
2
Press #/$ to select "HPLEVEL".
3
Press ENTER.
4
Press #/$ to adjust the volume level.
The setting has been established.
You can also use preamplifier's MODE and Multi jog dial.
See "Using MODE button" to perform this procedure on
the preamplifier
(➔
29).
Note
• When using the headphones, the balance setting will not be
applied.
• The preamplifier will end the setup if there is no operation for
8 seconds.
En
34
Selecting the Analog Audio Out
#, $
ENTER
SETUP
The TAPE OUT (LINE OUT) jack can produce audio
output by connecting the cassette tape deck with the
preamplifier.
1
Press SETUP.
2
Press #/$ to select "LINEOUT".
3
Press ENTER.
4
Press #/$ to switch between "LINEOUT" and
"RECOUT".
LINEOUT (LINE 3)
Outputs any signal from the input selector.
RECOUT (TAPE)
The selector name becomes TAPE. Signals input from
LINE 3 IN will not be output from LINE OUT.
5
Press ENTER.
"FINISH" appears on the display.
You can also use preamplifier's MODE and Multi jog dial.
See "Using MODE button" to perform this procedure on
the preamplifier
Tip
#, $
Usage example of RECOUT:
• Perform recording by connecting the turntable to P-3000R
ENTER
(PHONO IN jack), and the cassette tape deck to LINE 3
(IN/OUT jack) of P-3000R.
Note
• The preamplifier will cancel the setup if there is no operation for
8 seconds.
• When connecting a component such as a cassette tape deck,
change the "LINEOUT" setting to "RECOUT" for anti-
vibration purpose.
(➔
29).