Rear Panel - Onkyo P-3000R Instruction Manual

Rear Panel

a b
a GND screw
This screw is for connecting a turntable's ground wire.
b PHONO IN L/R jacks
These analog audio inputs are for connecting a
turntable (MM).
c CD IN L/R jacks
These analog audio inputs are for connecting a
compact disc player.
d LINE 1/2 IN L/R jacks
These analog audio inputs are for connecting a
playback device.
To input audio output (preout) to the preamplifier
from the AV receiver, set "L2 OUT" to
"THROUGH". The PRE OUT output of the
preamplifier is fixed at 0 dB.
You can output the audio signal coming from LINE 2
with a fixed volume (➔ 35).
e TAPE IN (LINE 3 IN) and TAPE OUT (LINE OUT)
jacks
These analog audio inputs and outputs are for
connecting a cassette tape deck.
f PRE OUT 1/2 L/R jacks
These outputs are for connecting a power amplifier.
c d e f
g u REMOTE CONTROL jack
This u (Remote Interactive) jack can be connected
to an u jack on an Onkyo Dock. The preamplifier's
remote controller can then be used to control the
Onkyo Dock.
To use u, you must make an audio connection
between the preamplifier and the Onkyo Dock. Other
Onkyo components cannot be controlled via u.
h 12V TRIGGER OUT jack
This output can be connected to the 12-volt trigger
inputs on the power amplifier.
i DIGITAL AES/EBU IN jack
This balanced AES/EBU input is for connecting a
component with balanced AES/EBU output, such as
compact disc players.
j DIGITAL COAXIAL IN 1/2 jacks
These coaxial digital audio inputs are for connecting
components with coaxial digital audio outputs, such as
compact disc players.
g h i j k l m n
k DIGITAL OPTICAL IN 1/2 jacks
These optical digital audio inputs are for connecting
components with optical digital audio outputs, such as
compact disc players.
l DIGITAL OPTICAL OUT jack
This optical digital audio output is for connecting an
AV receiver.
Digital input signals are put through and output on this
preamplifier as is.
m USB port
A PC can be connected here and the music can be
played through the preamplifier.
n AC INLET
The supplied power cord is connected here. The other
end of the power cord should be connected to a
suitable wall outlet.
See "Connections" for connection information
(➔ 15 to 24).
En
13