Connections; Cable And Jacks - Onkyo P-3000R Instruction Manual

Connections

Connections

Cable and Jacks

Balanced AES/EBU
USB digital audio
Optical digital audio
Coaxial digital audio
Analog audio (RCA)
u
Mono mini-plug
Note
• Push plugs in all the way to make good connections (loose connections can cause noise or malfunctions).
• To prevent interference, keep audio cables away from power cords and speaker cables.
• The preamplifier's optical digital jacks have shutter-type covers that open when an optical plug is inserted and close when it's removed. Push plugs in all the way.
• To prevent shutter damage, hold the optical plug straight when inserting and removing.
• The analog audio cable can be used instead of the coaxial cable.
About Balanced Input (AES/EBU Jack)
Plugging the AES/EBU cable
Match the pins and insert the terminal until you hear a "click." Make sure that the terminal is
locked by lightly pulling the connection cable.
This is a professional digital audio interface. Balanced AES/EBU cables are used for better noise immunity and longer cable runs. The maximum
sampling rate for PCM input is 192 kHz/24 bit, 2ch.
USB digital connections allow you to enjoy digital sound. The preamplifier supports high-speed USB 2.0. Use Type A-B USB cable. The maximum
USB
sampling rate for PCM input is 192 kHz/32 bit, 2ch.
Optical digital connections allow you to enjoy digital sound such as PCM. The maximum sampling rate for PCM input is 96 kHz/24 bit, 2ch. Input
OPTICAL
and output jacks are provided.
Coaxial digital connections allow you to enjoy digital sound such as PCM. The maximum sampling rate for PCM input is 192 kHz/24 bit, 2ch.
Orange
Analog audio connections (RCA) carry analog audio.
White
L
Red
R
To use u (Remote Interactive), you must make an audio connection between the preamplifier and the Onkyo Dock.
Use the supplied or commercially available mono mini-plug cable to connect to the 12V
trigger terminals on the other device for linked operation.
The tip polarity of the connectors are as shown in the right.
Unplugging the AES/EBU cable
Pull out the connection cable while holding down the lever.
1
Push
12 volts positive tip
polarity
Right!
Wrong!
2
Push
En
15