Table of Contents
Advertisement
Quick Links
PC66, PC66E
Sähkökiukaan asennus- ja käyttöohje
Monterings- och bruksanvisning för bastuaggregat
Instructions for Installation and Use of Electric Sauna Heater
Инструкция по установке�и эксплуатации электрической каменки для саун
Elektrikerise kasutus- ja paigaldusjuhis
Адрес:
ООО «Харвия РУС».
1
96084, г. Санкт-Петербург,
ул. Заставская, дом 7
E-mail: regionlog12@mail.ru
PC66
PC66E
01022017/Y05-0117
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Harvia PC6
Summary of Contents for Harvia PC6
- Page 1 PC66, PC66E Sähkökiukaan asennus- ja käyttöohje Monterings- och bruksanvisning för bastuaggregat Instructions for Installation and Use of Electric Sauna Heater Инструкция по установке�и эксплуатации электрической каменки для саун Elektrikerise kasutus- ja paigaldusjuhis Адрес: ООО «Харвия РУС». 96084, г. Санкт-Петербург, ул. Заставская, дом 7 E-mail: regionlog12@mail.ru PC66 PC66E...
-
Page 2: Table Of Contents
These instructions for installation and use are intended for the owner or the person in charge of the sauna, as well as for the electrician in charge of the electrical installation of the heater. After completing the installation, the person in charge of the installation should give these instructions to the owner of the sauna or to the person in charge of its operation. -
Page 3: Instructions For Use
1. INSTRUCTIONS FOR USE 1 .1. Piling of the Sauna Stones The piling of the sauna stones has a great effect on both the safety and the heating capability of the heater. Important information on sauna stones: The stones should be 5–10 cm in diameter. •... -
Page 4: Maintenance
stones in the middle lets the air flow through the heater, resulting in good heating of sauna and sauna stones. Do not drop stones into the heater. • Support the heating elements with stones so • that the elements stay vertically straight. Do not form a high pile of stones on top of the •... -
Page 5: Heater On
Figure 2. Timer switch Figure 3. Thermostat switch Obrázek 2 Vypínač časovače Obrázek 3 Vypínač termostatu 1 .3.1. Heater On Turn the timer switch to the ”on” section (section A in figure 2, 0–4 hours). The heater starts heating immediately. 1 .3.2. -
Page 6: Throwing Water On Heated Stones
1.4. Aufguss 1.4. Throwing Water on Heated Stones The air in the sauna room becomes dry when warmed up. Therefore, it is necessary to throw water on the heated stones to reach a suitable level of humidity in the sauna. The effect of heat and steam on people varies –... -
Page 7: Warnings
1 .6. Warnings Staying in the hot sauna for long periods of • time makes the body temperature rise, which may be dangerous. Keep away from the heater when it is hot. The • stones and outer surface of the heater may burn your skin. - Page 8 The sauna room heats quickly, but the temperature of the stones remain insufficient. Water thrown on the stones runs through. Turn the thermostat to a lower setting ( 1.3.4.). • Check that the heater output is not too high • ( 2.3.).
-
Page 9: Sauna Room
2. SAUNA ROOM 2.1. Sauna Room Structure Figure 4. Obrázek 4. A. Insulation wool, thickness 50–100 mm.The sauna room must be insulated carefully so that the heater output can be kept moderately low. B. Moisture protection, e.g. aluminium paper. Place the glossy side of the paper towards the sauna. -
Page 10: Sauna Room Ventilation
2 .2. Sauna Room Ventilation The air in the sauna room should change six times per hour. Figure 5 illustrates different sauna room ventilation options. min. 1000 mm 360° min. 500 mm 180° Figure 5. Obrázek 5. A. Supply air vent location. If mechanical exhaust ventilation is used, place the supply air vent above the heater. -
Page 11: Instructions For Installation
3. INSTRUCTIONS FOR INSTALLATION 3 .1. Before Installation Before installing the heater, study the instructions for installation. Check the following points: Is the output and type of the heater suitable for • the sauna room? The cubic volumes given in table 2 should be followed. -
Page 12: Electrical Connections
1 ,5 kg Figure 7. Installing the protective sheath Obrázek 7. Instalace ochranného štítu 3 .4. Electrical Connections The heater may only be connected to the electrical network in accordance with the current regulations by an authorised, professional electrician. The heater is semi-stationarily connected to •... - Page 13 Heater Output Dimensions Stones Sauna room Rozměry Saunová místnost Leistung Abmessungen Ofen Steine Saunakabine Kameny Topidlo Výkon Width/Depth/Height Weight Cubic vol. Height Výška Objem Ś í ř é ýš Váha ö Rauminhalt Höhe 2 .3.! min. m³ max. m³ min. mm max.
-
Page 14: Electric Heater Insulation Resistance
cable for electrical heating is brought directly into the junction box of the heater, and from there to the terminal block of the heater along a rubber cable with the same cross-section area as that of the connecting cable. 3 .4.1. Electric Heater Insulation Resistance When performing the final inspection of the electrical installations, a “leakage”... - Page 15 protector can be reset by pressing through the label with a screwdriver (Figure 10). Only persons authorised to carry out electrical installations can reset the overheat protector. Prior to pressing the button, the cause of the fault must be found. Are the stones crumbled and pressed •...
-
Page 16: Spare Parts
4 . VARAOSAT 4. RESERVDELAR NÁHRADNÍ 4. SPARE PARTS DÍLY 4 . ЗАПАСНЫЕ ЧАСТИ 4. VARUOSAD ZSC-022 (2200 W) x 3 ZSB-115 ZSK-520 ZSK-510 ZSB-125 ZSC-145 WX255 (PC66E) Suosittelemme käyttämään vain valmistajan varaosia. Använd endast tillverkarens reservdelar. We recommend to use only the manufacturer’s spare parts. Doporučujeme používat pouze originální...
Need help?
Do you have a question about the PC6 and is the answer not in the manual?
Questions and answers