Advertisement
PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
This Owner's Guide is designed to help you get a complete understanding of your new
Shark® POWERDETECT™ Upright Vacuum with Detect Technology, DuoClean® Detect, Powered
Lift-Away®, Self-Cleaning Brushroll, and Odor Neutralizer Technology.
SharkNinja Operating LLC
US: Needham, MA 02494
CAN: Ville St-Laurent, QC H4S 1A7
1-800-798-7398
sharkclean.com
Illustrations may differ from actual product. We are constantly striving to improve our products;
therefore the specifications contained herein are subject to change without notice.
This product may be covered by one or more U.S. patents. See sharkninja.com/patents for more
information.
© 2024 SharkNinja Operating LLC. DUOCLEAN, HAIRPRO, LIFT-AWAY, POWERED LIFT-AWAY, and
SHARK are registered trademarks of SharkNinja Operating LLC. FLOORDETECT and POWERDETECT are
trademarks of SharkNinja Operating LLC.
AZ4000Series�IB�E�MP�Mv12
Advertisement
Need help?
Do you have a question about the POWERDETECT AZ4000 Series and is the answer not in the manual?
Questions and answers
I vacuumed up some baking powder and now I want to clean it out. How do I do that?
To clean baking powder out of the Shark POWERDETECT AZ4000 Series vacuum, follow these steps:
1. Turn Off and Unplug – Ensure the vacuum is turned off and unplugged from the electrical outlet.
2. Empty the Dust Cup – Remove the dust cup and empty any baking powder inside.
3. Check for Blockages – Inspect the hose, wand, and nozzle for any clogs and remove debris.
4. Clean the Filters – The HEPA filter should be cleaned every year, and the pre-motor filters should be replaced every 2.5 years. Remove the filters and tap off excess dust. If necessary, rinse with water and allow them to dry completely before reinstalling.
5. Clean the DirtDetect Sensors – If the DirtDetect Indicator is red, clean the sensors as hair and fine particles may obstruct them.
6. Reassemble and Test – Once everything is clean and dry, reassemble the vacuum and test its functionality.
Avoid vacuuming fine powders frequently, as they can clog filters and reduce suction efficiency.
This answer is automatically generated
Can you turn off the beater bar off where there is just suction on the new PowerDetect power lift away vacuum. On the Navigator Lift Away there is switch on the handle that disengages the beater bar. Does new PowerDetect vacuum have this capability?
The manual does not explicitly mention a switch to turn off the beater bar for suction-only mode. However, it does state that for maximum suction for above-floor cleaning, the vacuum should be set to Hard Floor mode, which may imply reduced or no brushroll activity.
This answer is automatically generated
What is the length of the brushroll and soft roller?