Advertisement
Quick Links
CLUSTER SWIVEL BOOTH
PARTS AND ACCESORIES
A
B1
Table
Frame x1
F
Left Swivel
Control x2
Install Table Frame to Tabletop
1
follows: Begin by aligning the six Frame
holes over pilot holes on underside of
Tabletop. Using the six 25mm Pan-Head
Screws
, tightly fasten Screws to
7
Tabletop.
Page 1 of 4
ASSEMBLY INSTRUCTIONS
CLUSTER SWIVEL BOOTH SERIES | MOBILE TABLE
B2
Seat
Seat x4
Base x4
G
H
Right Swivel
Control x2
A
www.nationalpublicseating.com
HARDWARE
1
M8 x 16
Bolt x4
5
M8 x 45
Bolt x20
C
Connecting
Frame x2
I
Phillips
Hex Key
Wrench
as
P
7
2
3
M8 x 55
M6 x 10
Bolt x2
Screw x16
6
Nut x 26
D
E
Connecting
Seat frame x 2
Plate x 2
J
P
Open End
Wrench
A
P
4
Washer
x4
7
25mm
Pan-Headed
Screw x 6
Tabletop x1
1-800-261-4112
Advertisement
Related Manuals for National Public Seating CLUSTER SWIVEL BOOTH Series
Summary of Contents for National Public Seating CLUSTER SWIVEL BOOTH Series
- Page 1 ASSEMBLY INSTRUCTIONS CLUSTER SWIVEL BOOTH SERIES | MOBILE TABLE CLUSTER SWIVEL BOOTH HARDWARE M8 x 55 M8 x 16 M6 x 10 Washer Bolt x4 Bolt x2 Screw x16 25mm M8 x 45 Pan-Headed Nut x 26 Bolt x20 Screw x 6...
- Page 2 Align the holes on the flat side of two Align the holes on two Connecting connecting Frames with the holes Plates with the holes on two sides of on the Table Frame . Insert four Connecting Frames . Insert two M8 x 55 M8 x 16 bolts and tighten with four Bolts...
- Page 3 Align the holes on Seat Bases with the holes on Seat Frames . Insert two M8 x 45 Bolts and tighten with two Nuts using Enclosed Hex Key and Open end Wrench OPTIONAL SWIVEL CONTROL Turn Seat straight ahead. Place Swivel Control-L ...
- Page 4 After drilling, clear out the dust Drill the marked holes using electric Drill with 3/8 Drill bit to a depth from the holes using dust Blowing Ball . of 75mm. Align the holes on Fastening Plate with the Tighten Expansion Bolt using Wrench ...
Need help?
Do you have a question about the CLUSTER SWIVEL BOOTH Series and is the answer not in the manual?
Questions and answers