National Public
SEATING Corp.
149 ENTIN ROAD, CLIFTON, NJ 07014
ASSEMBLY INSTRUCTIONS FOR
CHECKERETTE / CHAIR CADDY #84
PARTS
(2) "T" Bars — PART A
(2) Crossbeams w/chair hangers — PART B
(1) Base crossbeam — PART C
(12) Bolts with nuts
(24) End Caps
Optional CHECKERETE parts:
(2) Removable coat rods — PART D
Optional TABLE-TRUCK parts:
(1) Extra Base crossbeam — PART C
Optional EXTENDER bar:
(2) Two small side bars
ASSEMBLY TIPS
All assembly should be done on a clean protected surface,
such as carpet or the like. Assembly is easy and should take
no more than 10 minutes.
ASSEMBLING THE UNIT
See other side of sheet for assembling unit with EXT-8
extender bars
STEP 1)
Make sure that there are NO missing or
damaged parts.
STEP 2)
While holding up one of the side "T" bars
(Part A), bolt crossbeam (Part B) into the
middle set of holes. NOTE: This set of holes
has three holes. Use the two lower holes.
When using the optional EXT-8 extender
bars (to use for higher chairs) use upper two holes.
STEP 3)
Take the other side "T" bar (Part A), and bolt it to crossbeam (Part B) in the middle set of holes.
NOTE: This set of holes has three holes. Use the two lower holes. When using the optional EXT-8
extender bars (to use for higher chairs) use upper two holes.
STEP 4)
Take the other crossbeam (Part B), and bolt it to the top sets of holes on both side "T" bars (Parts A).
STEP 5)
Finally, bolt crossbeam (Part C), into the bottom sets of holes on both side "T" bars (Parts A).
STEP 6)
Remove the end caps from the bag, and using a rubber mallet, attach them to the ends of the chair
hangers.
STEP 7)
Ascertain that each and every nut and bolt is securely tightened to its maximum!
OPTIONAL
STEP 8)
Attach coat rods (parts D) to the chair hanging rods (on parts B), use as coat rack when chairs are out.
CLIFTON, NJ 07014
|
MEMPHIS, TN 38106
WWW.NATIONAL PUBLIC SEATING.COM
|
TEL 973-594-1100
|
FAX 973-594-1500
|
ONTARIO, CA 91761