Sharp MultiSync EA272Q Setup Manual page 11

Usage of the product must not be accompanied by fatal risks or dangers that, could lead directly to
death, personal injury, severe physical damage or other loss, including nuclear reaction control in
nuclear facility, medical life support system, and missile launch control in a weapon system.
PROHIBITED
Handling the power cord.
The monitor should be installed close to an easily accessible power outlet.
REQUIRED
When connecting the power cord to the product's AC input terminal, make sure the connector is
fully and firmly inserted.
An incomplete connection of the power cord may cause overheating of the plug; it allows dust to
get on the plug connection, which can lead to a fire. Touching the pins of a partially inserted plug
REQUIRED
may lead to an electric shock.
Handling the power cord by following below to avoid fire or electric shock.
• When connecting or disconnecting the power cord, pull the power cord out by holding onto its
plug.
• Unplug the power cord from the power outlet before cleaning the product or when not planning to
use the product for an extended time.
REQUIRED
• When the power cord or plug is hot or damaged, unplug the power cord from the power outlet,
and contact a qualified service person.
Regularly dust off the power cord by using a soft dry cloth.
REQUIRED
Before moving the product, make sure the product power is off, then unplug the power cord
from the power outlet and check that all cables connecting the product to other devices are
disconnected.
REQUIRED
Do not use the power cord with a power tap.
Adding an extension cord may lead to fire as a result of overheating.
PROHIBITED
Please confirm the distribution system in building installation shall provide the circuit breaker rated
120/240 V, 20 A (maximum).
REQUIRED
Do not bind the power cord and the USB cable.
It may trap heat and cause a fire.
PROHIBITED
Do not connect to a LAN with excessive voltage.
When using a LAN cable, do not connect to a peripheral device with wiring that might have
excessive voltage. Excessive voltage on the LAN terminal may cause an electric shock.
PROHIBITED
Do not climb on the table where the product is installed. Do not install the product on a wheeled
table if the wheels on the table have not been properly locked. The product may fall, causing
damage to the product or personal injury.
PROHIBITED
WARNING
CAUTION
English-5
EN