Vacmaster VBVB1518PF 01 Manual page 12

For Wet Vacuuming:
1) To prepare your vacuum cleaner for wet vacuuming, remove the pre-filter. Verify that the
washable cartridge filter is installed.
NOTE: Please make sure the washable cartridge filter is dry before using it for wet vacuuming.
IMPORTANT! The vacuum cleaner is equipped with a float valve (
wet suction (Fig. 9). The suction power decreases when the maximum filling level is reached.
You will notice an increase in motor noise. When this happens, switch the vacuum cleaner off
immediately, and empty the container.
3. Blower Operation
WARNING:
WARNING:
INHALED.
1) Make sure the container and any collected waste is emptied and the filter is dry before using as
a blower.
2) Insert the locking end of the suction hose into the blowing port on the rear of the power head (Fig.
10).
3) Turn on the motor by turning the switch to the 'I' ON position.
For Detachable Blowing Operation:
This wet/dry vacuum converts to a detachable blower that can be used for leaf blowing in gardens,
on decks, and patios.
1) Hold the blower handle and press the blower release button to lift the detachable blower from
the blower housing (Fig. 11 & 12).
2) Secure the locking end of the blower adapter onto the blower port (Fig. 13).
3) Fit the blower tube onto the adapter. Make sure the blower tube is secured into place (Fig. 14).
4) Firmly hold the blower before turning it on. Turn the appliance on by turning the switch to the 'I'
ON position.
NOTE: Make sure that the detachable blower is replaced properly onto the blower housing when
finished blowing.
OPERATION
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
) which is operational during
2
12
GB