Parts And Functions - Haier HSU09XCK Operation Manual

Parts and Functions

Indoor Unit
1
2
3
4
Inlet
1
2 Inlet grille
3 Outlet
Vertical blade
4
(adjust left and right air flow)
Horizontal flap
5
(adjust up and down air flow.
Don't adjust it manually)
Please be subject to the actual produce purchased the
above picture is just from your reference
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
8
6
7
5
6
Display board
Emergency Switch
7
Air Purifying Filter
8
(inside)
4
Remote controller
1
2
3
4
5
9
10
11
12
13
14
15
16
1. Mode display
Operation mode
AUTO COOL DRY FAN
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
LO MED HI AUTO
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
Healthy function is not available for some units.
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance from the remote to the receiver should be less than
23 feet (7 meters) with no obstructions.
Fluorescent lights or cordless telephones will reduce the range
of the remote.
If the display is dim the remote batteries may need to be replaced.
Remote malfunctions can sometimes be corrected by removing
the batteries for a few minutes and then replacing them.
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
8. Additional functions display
6
Operation mode
QUITE SLEEP HEALTH
Remote controller
7
9. QUIET button
10. COOL button
11. AUTO button
12. FAN button
8
13. TIMER button
17
14. HEALTH button
15. LOCK button
Used to lock buttons and LCD display
18
16. LIGHT button
19
Control the lightening and extinguishing
of the indoor LED display board.
20
17. POWER ON/OFF button
18. DRY button
21
19. TEMP button
20. SWING button
22
21. HOUR button
23
22. EXTRA FUNCTION button
Function: Air sending--- Healthy
24
airflow position1--- Healthy airflow
position 2 --- Restore the original
flap position --- Right & left air airflow
--- A-B yard--- Sleeping--- Refresh air
) --- Power ---
(reserved function
Fahrenheit/Celsius mode conversion
23.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
24. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
the remote.
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 AAA batteries, resetting key
(cylinder);
3
Be sure battery polarity is
correct " + "/"-";
POWER
1