Out The Box - Whyte Kynamic RHeO 1 Owner's Manual

OUT THE BOX

This manual is not intended as a comprehensive guide to assembling,
servicing, and maintaining your bicycle. Please see your authorised
Whyte Bikes Retailer for assembly guidance, service, repairs, and
maintenance.
INFO: Specification of all the components that are fitted to your
bike as standard may be obtained from the Whyte Bikes website
www.whytebikes.com
WARNING: If you are in any doubt about your ability to safely
service or repair your Whyte bike, DO NOT RIDE IT and instead
arrange for a professional bicycle mechanic at your local Whyte
Retailer to do the job correctly.
WARNING: Before any ride check all fixings are tight and secure.
This is very important to ensure the bikes performance and your
safety. Please read the Pre-Ride Checks section of this manual
and learn what is required to operate this bicycle. Correct
tightening force on fasteners (nuts, bolts and screws) is critical.
Too much force can cause damage to the fixing and too little
force could cause them to undo or rattle loose. Where indicated
in the instructions or printed on the fixing please adhere to the
recommended torque specification. Please see recommended
tools and torque settings.
When unboxing your new Whyte bike you will find an accessories box
containing numerous manuals (Including this manual). Please ensure you
read all relevant literature prior to assembly or riding your bike. Relevant
manufacturer manuals for your bikes components will be provided.
Ensure all documents are retained for assistance with maintenance,
cleaning, and warranty.
Your Whyte accessories box contains components that are specific to
your bike. Follow the instructions provided or please contact your Whyte
Retailer for any support required.
Tools Required For Assembly:
• 4,5,6,8mm Allen key
• Adjustable spanner
• Bicycle Pump
• Torque Meter Wrench (Optional) 15mm Spanner
• Philips Head Screwdriver
Accessory Part Instructions:
In the bicycle accessories kit you will find numerous components
relevant to your bicycle. If your bicycle is supplied with pedals you
will need a 15mm spanner to fit them to the cranks. Ensure you have
identified the right and left pedal prior to installation. Tighten pedals to
a recommended 40.2-42.9 Nm (350-380 lb/in). A Philips screw driver is
required to mount reflectors to your bicycle. Reflectors are a crucial part
of the safety system and must not be removed. Before riding your Whyte
bicycle please inform yourself of all applicable legal requirements to ride
safely in your country/state.
10