Operation - Haier HPU-42CV03 Operation And Installation Manual

Operation

Clock set
When unit is started for the first time
and after replacing batteries in remote
controller, clock should be adjusted as follows:
Press CLOCK button, "AM"or "PM" flashes.
1
Press or to set correct time. Each press will increase
2
or decrease 1 min . If the button is kept pressed, time will
change quickly.
3
After time setting is confirmed, press SET, "AM" and "PM"
stop flashing, while clock starts working.
Remote controller's operation
When in use, put the signal transmission
head directly to the receiver hole on the
indoor unit
The distance between the signal transmission
head and the receiver hole should be within
7m without any obsacles as well.
Don't throw the controller, prevent it from
being damaged.
When electronic-started type fluorescent
lamp or change-over type fluorescent lamp
or wireless telephone is installed in the room,
the receiver is apt to be disturbed in receiving
the signal so the distance to the indoor unit
should be shorter.
Loading of the battery
Slightly press "
Load the batteries as illustrated.
2 R-03 dry batteries, (cylinder)
Be sure that the loading is in line with the "+"/"-" pole
request as illustrated.
Put on the cover again.
Confirmation indicator:
In disorderation, reload the batteries or load the new batteries
after 5 mins.
Note:The waster batteries should be disposed properly,use two
new same-type batteries when loading.
If the remote controller can't function normally or doesn't work at
all,use a sharp-pointed item to press the reset key.
Hint:Remove the batteries in case unit won't be in usage for a long period.
If there are any displays after taking-out just need to press reset key.
When throw away the waste batteries, please perform in accordance with the local regulation.
" and push down the cover.
MODE
SLEEP
CLOCK
1 TIMER
RESET
5
SWING
SET
3
2
HEAT
LIGHT LOCK
2R-03 dry batteries