Haier HPU-42CV03 Operation And Installation Manual page 8

Operation
TEMP
3
ON
3
1
OFF
FAN
HEALTH
4
5
MODE
SLEEP SWING
CLOCK SET
TIMER
HEAT
RESET LIGHT LOCK
In DRY mode, when room temp.becomes 2 C higher than temp.
setting,unit will run intermittently at LOW speed regardless of FAN
setting.
Note:
During Auto run operation, temp. setting will be shown in LCD display, unit will select heating, cooling
or fan operation according to the room temp.
ON
ON
MODE
ON/OFF FAN
2
1 4
Control panel
AUTO
Press ON/OFF button
1
Unit starts running.
The previous status appears on the display
(except. TIMER, SLEEP mode)
Press MODE button. For each press,
2
operation mode changes as follows:
Remote
controller
Then select AUTO run or select COOL operation or
select DRY operation or select HEAT operation
3 Select temp. button
Press TEMP button
Every time the button is pressed, temp.
TEMP+
setting increases 1 C
Every time the button is pressed, temp.
TEMP-
setting decreases 1 C
If the button is kept pressed, setting will
increase or decrease quickly.
4 Press FAN,For each press, operation mode
changes as follows:
Remote
controller
Unit runs at the speed displayed on LCD.
When fan speed is AUTO,it is changed automatically
according to the indoor temperature.
The fan speed change of the control panel see page 12.
Press ON/OFF button Unit stops running.
5
COOL operation starts when room
temp. is higher than temp. setting.
Temp.setting+2 C
Temp.setting
On reaching 2 C higher than temp.
setting,unit will run in mild DRY mode.
6
TEMP
TEMP
3
FAN
COOL DRY
HEAT
AUTO COOL DRY FAN
LOW MID HIGH
Ultra-low air flow
TEMP HEALTH
3
HEAT
AUTO