Aiwa CSD-ED87 Operating Instructions Manual page 5

o-9, +10
BAN D
II PAUSE
1
2
3
Press CD.
The power is turned on and the CD indicator lights up.
Press OPEN to open the disc compartment.
Place a disc with the printed side up and
close the disc compartment.
~~OPEN
Total number of tracks and total playing time are
displayed.
Press '-11 PLAY/PAUSE/PRESET to start
play.
The number of the track being played and elapsed
playing time are displayed.
* or ~ PLAY on the remote control
STOP/MEMORY – Stops play.
,.
">11 PLAY/PAUSE/PRESET – Pauses play. To resume
play, press again.
* or II PAUSE on the remote control
1++, M SKIP/SEARCH – Searches for a particular point
during playback. Keep H or M pressed and then
release it.
– Skips to the beginning of a track. Press W or M
repeatedly.
*REPEAT/FM MODE/OSC – Repeats a single track or all
tracks. Select as follows.
(= 1: A single track is played repeatedly. Select a track
with K+ or M.
G : All tracks are played repeatedly.
' or REPEAT on the remote control
To start play when the power is off, press
CD.
The
power is turned on and play of the loaded disc begins
(Direct Play Function).
If you load a disc while the CD indicator flashes in step 2,
play starts without pressing -11.
To select a track directly with the remote control, press
the numbered buttons O-9 and +1 O. CD play starts from
the selected track and continues to the last track.
Example:
To select number 25, press +1 O, +1 O and 5.
To select number 10, press +10 and O.
After listening, press POWER 6 STANDBY to turn the
power off.
NOTE
Do not use irregular shape CDs (example: heart-shaped,
octagonal ones).
It may result in malfunctions.
Do not place more than one disc in the disc compartment.
Do not try to open the disc compartment during play.
Do not touch the lens. Doing so may cause malfunctions.
Up to 30 tracks can be programmed from the disc.
~ In stop mode, keep 'H STOP/MEMORY
pressed until "M" flashes in the display.
* or on the remote control
z Press 144, Fl to select a track, then press
STOP/MEMORY to store it.
Track number
Programmed number
To select a track with the remote control
Press the numbered buttons O-9 and +1 O.
.3
Repeat step 2 to program other tracks.
4
Press -II to start play.
To check the program, press - or H in stop mode.
To clear the program, press ti in stop mode so that "M"
disappears in the display.
To change the programmed tracks, clear the program and
repeat all the steps again.
To listen with the headphones
Connect headphones with a stereo mini plug to the Q jack.
ENGLISH
5