Toto EA TX471KEA Quick Start Manual

SPECIFICATIONS
150±10
5.5
G½
OPERATING CONDITIONS
1. Water supply pressure : 0.05 ~ 0.75 MPa.
2. Ensure that water supply is clean ( No Sand, Dirt, Etc.).
ATTENTION
1. Don t use abrasive cleaners or solvents on faucets and
fittings.
2. Flow Regulator should not be remove because it could
damage the system
3.
As the product model is constantly updated, the actual
product may not look the same as it shown in the
diagram, but the basic installation principles are the same.
4.
The hot water supply side of the faucets is in a condition
of high temperature. Do not allow skin to contact with the
hardware surface directly. Otherwise,
scalding may occur.
S060459S
"EA" SINGLE LEVER BATH & SHOWER SET TX471KEA
INSTALLATION
1
MOUNT CONNECTORS PARALLEL WITH THE WALL
Hot
Water
Supply
Leg
2
* Tighten the nut
30
74
Body
3
0
164.5
-7
Screw
4
Cold
150±10
Water
Supply
Use Seal tape
(Not Include)
150
Nut *
Cover
Packing
2 X Ø5.5 Holes
Sleeve Anchor
Hanger
Hand Shower
Packing
Flexible Hose
Packing
TROUBLESHOOTING
CHECK
PROBLEM
POINT
Unsatisfactory spray
Flow rate unsatisfactory
Water leaks around the handle
Handle is loose
1. NOZZLES
Flow Regulator Inside
(Don t remove)
3. CONNECTING NUT
4. BOLT
2. AERATOR
MAINTENANCE
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and are
not recommended for cleaning
SOLUTION
1
Clean
2
Remove and clean
3 Tighten
4 Tighten
R4