Toto PLANO TX471SPV1 Quick Installation Manual

SPECIFICATIONS
150±10
G½
OPERATING CONDITIONS
1. Water supply pressure : 0.05 ~ 0.75 MPa.
2. Ensure that water supply is clean ( No Sand, Dirt, Etc.).
ATTENTION
1. Don t use abrasive cleaners or solvents on faucets and
fittings.
2. As the product model is constantly updated, the actual
product may not look the same as it shown in the
diagram, but the basic installation principles are the same.
The hot water supply side of the faucets is in a condition
3.
of high temperature. Do not allow skin to contact with the
hardware surface directly. Otherwise,
scalding may occur.
S060158-1N
"PLANO" SINGLE LEVER BATH & SHOWER MIXER
MAINTENANCE
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and
are not recommended for cleaning
INSTALLATION
1
MOUNT CONNECTORS PARALLEL WITH THE WALL
Hot
WALL
Water
Supply
G½
Leg
0
153
-7
2
Body
*Tig the n the nut b y wrench.
W/O HAND SHOWER SET
TROUBLESHOOTING
Water leaks around the handle
Handle is loose
Cold
Water
150±10
Supply
Use Seal tape
(Not Include)
150
Cover
Packing
Nut *
TX471SPV1
CHECK
PROBLEM SOLUTION
POINT
Tighten
1
Tighten
2
1. CONNECTING
NUT
2. BOLT
R7