Advertisement
Quick Links
CC200 Series
Cartridge Check Valve
Instruction Manual
Failure to follow these instructions or to properly install and maintain this equipment could result in gas leak-
age, fire or explosion causing property damage and personal injury or death.
Oasis products must be installed, operated and maintained by trained and competent personnel in
accordance with all applicable local codes, rules and regulations in addition to the Oasis Instructions.
Oasis Engineering Ltd. will not be held liable in such circumstances where installation, operation and
maintenance procedures were performed by incompetent personnel resulting in improper assembly, unsafe
operation, equipment damage or personal injury.
Oasis recommends that all service technicians should watch the Product Servicing Video before attempting to
service this part.
Oasis Engineering Ltd
129 Birch Avenue, Tauranga, New Zealand.
T: +64 7 928 3808
E: info@oasisNGV.com
W: www.OasisNGV.com
Instruction Manual
Advertisement
Related Manuals for Oasis CC200 Series
Summary of Contents for Oasis CC200 Series
- Page 1 Oasis products must be installed, operated and maintained by trained and competent personnel in accordance with all applicable local codes, rules and regulations in addition to the Oasis Instructions. Oasis Engineering Ltd. will not be held liable in such circumstances where installation, operation and maintenance procedures were performed by incompetent personnel resulting in improper assembly, unsafe operation, equipment damage or personal injury.
- Page 2 High pressure gas and gas equipment can cause serious harm to both infrastructure and personnel if safety precautions are not followed. Oasis recommends considering the use of the following PPE when working with high pressure along with any other site specific health and safety requirements:...
-
Page 3: Installation Instructions
Caution This valve is intended for use in embedded manifold systems that have been designed according to Oasis specifications. Use in non-conforming manifold systems could damage the valve and manifold and will void warranty. See page 10 for manifold pocket dimensions. - Page 4 CC204 - 120Nm CC206 - 180Nm Note: Oasis recommends routine back pressure leakage testing as part of a good preventative maintenance schedule and servicing the valves as required. This will ensure safe and reliable operation over their life time. CC200-INS-01 1123 © Oasis Engineering Limited...
- Page 5 CC204 = 126 O-ring & Backup CC204 = 125 O-ring & Backup CC206 = 135 O-ring & Backup CC206 = 134 O-ring & Backup The Complete Oasis Seal Kit must be used Tools Required Cleaner (Warm Vice Anti Seize Grease...
- Page 6 5. Place hex of valve end cap in vice with body side facing up. Use spanner or socket to loosen body, then unthread by hand. Do not scratch outer or inner surface of body CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 7 9. Clean components and inspect for damage. Check for excessive damage to sealing faces, end cap and Do not scratch poppet retainer outer or inner surface of body CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 8 3. Secure end cap in vice and insert spring 4. Carefully place body on end cap and screw and poppet, then place insert onto end cap. together by hand. CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 9 The check valve body may mounted into retainer cage with flow going in either direction. Refer manifold manufacturers directions for correct orientation for the application. CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 10 Manifold pocket dimensions See specification sheet for full-manifold pocket information. CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 11 Notes CC200-INS-01 1123 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
Need help?
Do you have a question about the CC200 Series and is the answer not in the manual?
Questions and answers