Advertisement
CV300 Series
Check Valve BSP
Instruction Manual
Failure to follow these instructions or to properly install and maintain this equipment could result in gas leak-
age, fire or explosion causing property damage and personal injury or death.
Oasis products must be installed, operated and maintained by trained and competent personnel in
accordance with all applicable local codes, rules and regulations in addition to the Oasis Instructions.
Oasis Engineering Ltd. will not be held liable in such circumstances where installation, operation and
maintenance procedures were performed by incompetent personnel resulting in improper assembly, unsafe
operation, equipment damage or personal injury.
Oasis recommends that all service technicians should watch the Product Servicing Video before attempting to
service this part.
Oasis Engineering Ltd
129 Birch Avenue, Tauranga, New Zealand.
T: +64 7 928 3808
E: info@oasisNGV.com
W: www.OasisNGV.com
Servicing Video
Instruction Manual
Advertisement
Table of Contents
Related Manuals for Oasis CV300 Series
Summary of Contents for Oasis CV300 Series
- Page 1 Oasis products must be installed, operated and maintained by trained and competent personnel in accordance with all applicable local codes, rules and regulations in addition to the Oasis Instructions. Oasis Engineering Ltd. will not be held liable in such circumstances where installation, operation and maintenance procedures were performed by incompetent personnel resulting in improper assembly, unsafe operation, equipment damage or personal injury.
- Page 2 High pressure gas and gas equipment can cause serious harm to both infrastructure and personnel if safety precautions are not followed. Oasis recommends considering the use of the following PPE when working with high pressure along with any other site specific health and safety requirements:...
- Page 3 Note: Oasis recommends routine back pressure leakage testing as part of a good preventative maintenance schedule and servicing the valves as required. This will ensure safe and reliable operation over their life time.
- Page 4 1 x Seat 1 x Poppet Spring 1 x End Cap O-ring 1 x End Cap Backup 1 x Silicone Grease The Complete Oasis Seal Kit must be used Tools Required Anti Seize Grease Cleaner (Warm Soapy Pick Tool (Loctite 771 or Similar)
- Page 5 3. Carefully remove body from valve. 4. Discard check valve poppet and spring. Do not throw away the stainless steel insert. CV300-INS-04 2822© Oasis Engineering Limited CV300-INS-04 2822© Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 6 Do not scratch body 7. Clean components and inspect sealing faces for damage. Check for excessive damage to sealing faces and poppet retainer CV300-INS-04 2822 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 7 4. Carefully place body on end cap and screw and poppet then place insert onto end cap. together by hand. CV300-INS-04 2822© Oasis Engineering Limited CV300-INS-04 2822© Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
- Page 8 CV308 - 150Nm 7. Servicing complete, refer to installation instructions on page 3 for re-installation of product. Replace Dowty seals when re-installing valve. CV300-INS-04 2822 © Oasis Engineering Limited We reserve the right to modify product specifications without prior notice.
Need help?
Do you have a question about the CV300 Series and is the answer not in the manual?
Questions and answers