How It Works; Water Shortage Protection; How To Assemble - FOHERE JSQ-E50S2 User Manual

HOW IT WORKS

1. Water is released into the reservoir when the float paddle engages the plunger at
the bottom of the water tank. An atomizer vibrates at ultrasonic frequency,
breaking the water into a fine mist. The mist is quietly propelled by a fan up a
vertical mist chamber to the mist outlet where the cool, visible mist enters the
room. When the water volume is low, the red light will illuminate to indicate and
the machine will stop the mist output. Then the machine will in standby mode to
protect it from dry burning and other problems when there is a water shortage.
2. In order to completely discharge the mist inside, a er this product goes standby
and the atomizer stops operation, the blower continues working until a delayed
time.

WATER SHORTAGE PROTECTION

When this product runs short of water during operation, the lighting ring flashes a few
times in red and then stay on in red, it means the machine is out of water. Need to
shut down,add water again, the machine works normally a er restarting.

HOW TO ASSEMBLE

1.MIST TUBE ASSEMBLY
Insert the mist guide into the upper
lid and then turn it till it is fixed.
(Remark: The mist nozzles on both
sides can be turned to tighten or
loosen to control whether to output
mist.)
Mist nozzle
control switch
Mist Tube
Upper Lid
2.WATER TANK ASSEMBLY
Reverse the water tank, insert the
valve assembly into the tank and
then turn it till it is fixed.
Water Tank
08
Valve