Power Supply; Connections - Aiwa CA-DW635 Operating Instructions Manual

POWER SUPPLY
CONNECTIONS
Connect the AC cord as illustrated below.
m
V
.
~
to
the
AC
inlet of the unit
~+ ~ to an AC outlet
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Open the lid of the battery compartment on the rear and
insert eight R20 (size D) batteries, not supplied, as illustrated
below. Then close the lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
Batteries wear excessively when the cord is connected.
I
\
p.
*D)
The batteries need to be replaced when:
The OPE/BATT indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted during
operation.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
Insert the batteries with the 0 and
O
marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
Never recharge the batteries, apply heat to them or take
them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
IMPORTANT
Make sure that the AC cord is disconnected and batteries
are removed before connecting speakers.
Do not connect other than the supplied speakers.
1
2
Position the speakers.
To couple with the speakers, slide each speaker down
into the guide brackets on the center unit until the height
is level with the unit.
To separate the unit from the speakers, slide the
speakers up and off, while pressing the speaker release
knob.
Connect the s~eakers.
Connect the righ~ speaker cord to the R terminals, and
the left speaker cord to the L terminals.
Connect the speaker cord with the white broken line to
0 and the other cord to
O.
~~
o
Sound signals can be input to this unit through the AUX/
VIDEO jacks.
Use a cable with RCA phono plugs (not supplied) to connect
the external equipment.
Connect the red plug to the R jack, and the white plug to the
L
jack.
To listen to the external source
Press AUX and play the equipment.
Refer also to the operating instructions of the connected
equipment for details.
4
ENGLISH