Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Genelec 3440A
Summary of Contents for Genelec 3440A
- Page 1 3440A Operating Manual Genelec 3440A Smart IP Subwoofer...
-
Page 2: Installation
PoE+ or PoE standards. Using PoE+ amplifier is recommended for achieving the full • Switched-mode power supply technology When placed on the floor, the 3440A can performance of the 3440A. The proprietary offering high SPL output using standard be placed in an upright position (factory... - Page 3 PoE supply and therefore Genelec recommends the use of PoE+ supply. When Figure 2. 3440A and three 4435A In-Ceiling loudspeakers powered with PoE+ IP switch. the audio signal demands more output power than available at the PoE power the 3440A Ethernet port.
-
Page 4: Network Structure
15 W for PoE and 30 W for PoE+. Ensure that the total power Figure 3. 3440A powered by an IP PoE+ power injector does not exceed the switch or power injector total power. -
Page 5: Analogue Input
Time profile of PoE+ audio power usage Figure 4. 3440A power supply enables high output level peaks exceeding the incoming PoE power level; the PoE standard limits the duration of the peaks Analogue Input Name Standard Power at switch Min. -
Page 6: Reset Button
API command or in response to IP audio stream. The power consumption in the ISS state for 3440A is 4 W. To save more power, the PoE+ power supply in the Ethernet switch or PoE injector can be turned off. -
Page 7: Maintenance
Crossover audio-over-IP stream in the stream input. Set stream again to resume normal streaming operation. Bass management for the 3440A subwoofer This adjustment sets a crossover frequency and main loudspeakers in the system is between the main loudspeakers and the Status Indicator LED done in Smart IP Manager software. - Page 8 Using a safety wire is recommended. • Genelec products and accessories come with instructions on the proper methods of installation and use. Follow these instructions. WARNING!
- Page 10 Maximum short-term output level is limited by the PoE technology being used and the crest factor of the audio signal. The stated values are typical for music and speech signals. Maximum long-term output level can be further limited by loudspeaker system protection. Genelec recommends using PoE+ whenever possible. Using lower-power PoE can limit short-term maximum and long-term maximum, depending on the characteristics of the signal being reproduced.
- Page 11 PoE (supports signature) IEEE 802.3af Ethernet cable specification 5, 5e, 6 Maximum Ethernet cable length 100 m (333 ft) Power consumption in idle Power consumption in ISS power-down mode 200 mm [7 7/8 inch] 220 mm [8 11/16 inch] 475 mm [18 11/16 inch] 4 M6 thread inserts. Maximum screw length 20 mm (3/4 inch) Figure 8. Dimensions of the 3440A...
- Page 12 Genelec 3440A Smart IP Subwoofer www.genelec.com Genelec Document D0219R001. Copyright Genelec Oy 4.2024. All data subject to change without prior notice International enquiries: In the U.S. please contact: In China please contact: In Japan, please contact: In Sweden please contact Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the 3440A and is the answer not in the manual?
Questions and answers