This manual addresses setting on the chosen mode of bass management, (100-240 VAC, 50-60 Hz) and enables the up and using the Genelec 7360A and 7370A these outputs may carry either unfiltered or subwoofer to be plugged in anywhere subwoofers.
Page 3
3D immersive setups including when a computer is not in use. Genelec • Connect a CAT5 (RJ45) cable between also one or more subwoofers. GLM setup is...
Page 4
(use menu item “Store | Store the Current Group Settings…”). Phase Difference: 270° Phase Difference: 180° While the GLM network is disconnected the settings stored using the Genelec Loudspeaker Manager software can be can 85 Hz 85 Hz be retrieved and activated by setting the STORED switch ON.
Manual Phase Additional Information Adjustment Method Positioning Subwoofer in Room Genelec 7360A and 7370A subwoofers are equipped with a built-in 85 Hz frequency The location of the subwoofer can affect test tone generator for phase alignment. the frequency response and sound level...
Maintenance or repair must 7360A. 7370A. only be done by a Genelec certified service. Guarantee Genelec guarantees the subwoofers for • Free flow of air behind and around the instructions, may cause harmful interference...
Connection 2 RJ45, CAT5 cables software frequency response adjustment parametric notch filters System calibration Genelec GLM AutoCal™ Crossover subwoofer/subwoofer output channels Centralized Bass Management Subwoofer: low pass 85 Hz, output: high pass 85 Hz Distributed Bass Management (GLM control only)
Page 8
7360A and 7370A Operating Manual www.genelec.com Genelec Document D0134R001a. Copyright Genelec Oy 9.2016. All data subject to change without prior notice International enquiries: In Sweden please contact In the U.S. please contact: In China please contact: Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the 7370A and is the answer not in the manual?
Questions and answers