This manual addresses setting control using the Genelec Loudspeaker configurations: up and using the Genelec 7360A and 7370A Manager (GLM) software. Bypass connector supports a ¼ in subwoofers. These subwoofers are designed • All channels routed through the...
Page 3
50 / 60 Hz 300 W BUTTON FOR 10 SEC 100 - 240 V~ Figure 1. Connector panel ROTARY POWER AES/EBU IN/OUT of the 7360A. The 7370A LEVEL SWITCH CONNECTORS ADJUSTMENT is similar. The setup is fast and consists of the...
Page 4
Loudspeaker Manager Software and the The “LFE +10 dB” function can add the GLM control network and provide superior Genelec 7360A and 7370A subwoofers are +10 dB of gain to the LFE channel in the functionality compared to subwoofer's equipped with a built-in 85 Hz frequency production stage if it is not already done own controls.
Maintenance or repair must This device complies with part 15 of the FCC experimentation is needed to find the only be done by a Genelec certified service. Rules. Operation is subject to the following location giving the flattest frequency...
Page 6
• Connect the equipment into an outlet on Level vs Freq (Hz) 7360A 25.4.16 Level vs Freq (Hz) 7370A 25.4.16 a circuit different from that to which the +100 +100 Bass Bass LFE channel LFE channel receiver is connected. Roll-Off...
Connection 2 RJ45, CAT5 cables software frequency response adjustment parametric notch filters System calibration Genelec GLM AutoCal™ Crossover subwoofer/subwoofer output channels Centralized Bass Management Subwoofer: low pass 85 Hz, output: high pass 85 Hz Distributed Bass Management (GLM control only)
Page 8
7360A and 7370A Operating Manual www.genelec.com Genelec Document D0134R001 Copyright Genelec Oy 5.2016. All data subject to change without prior notice International enquiries: In Sweden please contact In the U.S. please contact: In China please contact: Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the 7360A and is the answer not in the manual?
Questions and answers