Kodak HR User Manual page 77

Removing the Long Roll Accessory from the Scanner
It may be necessary to remove the Long Roll Accessory from the scanner.
CAUTION: Make sure the scanner is powered OFF.
To remove the Long Roll Accessory, reverse the installation procedure (see pages
D-8 through D-12 for more details):
May 2002
1. Remove the aperture plate from the Long Roll Accessory. See Latching and
Unlatching the Gate Actuator on page D-11.
2. Power off the scanner.
CAUTION: When removing the mounting screws in the next step, use care
to avoid dropping the screws inside the scanner.
3. Loosen and remove the 3 mounting screws.
CAUTION: Avoid hitting the light bar and the safety switch.
4. Remove and lift the Long Roll Accessory from the scanner.
5. Place the Long Roll Accessory on a flat surface.
Using the Long Roll Accessory
D-13