Appendix D-4: Initial Setup Of Sensors - Kodak HR User Manual

Using the Long Roll Accessory

Appendix D-4: Initial Setup of Sensors

D-38
IMPORTANT: Do this procedure only if you installed a new sensor or if the sensor
setup was accidentally changed.
Resetting the Sensors to the Factory Values
1. Move SET/ADJ/RUN to SET.
2. Simultaneously, press and hold TEACH and MODE until nO ? appears (about
5 seconds).
NOTE: To cancel resetting the sensors to the factory values, press MODE.
3. Press TEACH until yES? appears.
4. Press MODE.
5. Move SET/ADJ/RUN to RUN.
TEACH ADJ MODE
SET RUN L D
TEACH ADJ MODE
SET RUN L D
TEACH ADJ MODE
SET RUN L D
May 2002