Table of Contents
Advertisement
Chapter 2 Installation
P4i45D is an ATX form factor (12.0" x 7.0", 30.5 x 17.8 cm) motherboard. Before you
install the motherboard, please study the configuration of your chassis to ensure that
the motherboard fits into it.
Make sure to unplug the power cord before installing or re-
moving the motherboard. Failure to do so may cause physical
injuries to you and damages to motherboard components.
2.1 Screw Holes
Please place screws into the holes indicated by circles to secure the motherboard to
the chassis.
Do not over-tighten the screws! Doing so may damage the
motherboard.
2.2 Pre-installation Precautions
Take note of the following precautions before you install motherboard components
or change any motherboard settings.
1.
Unplug the power cord from the wall socket before touching any component.
2.
To avoid damaging the motherboard components due to static electricity, NEVER
place your motherboard directly on the carpet or the like. Also remember to use
a grounded wrist strap or touch a safety grounded object before you handle
components.
3.
Hold components by the edges and do not touch the ICs.
4.
Whenever you uninstall any component, please place it on a grounded antistatic
pad or in the bag that comes with the component.
Before you install or remove any component, pleasse ensure that the
power is switched off or the power cord is detached from the power
supply. Failure to do so may cause severe damage to the motherboard,
peripherals, and/or components.
Advertisement
Table of Contents
