Connectors - ASROCK P4I45D R3.0 User Manual

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.7 item 14)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1, see p.7 item 8)
IDE1
PIN1
connect the blue end
to the motherboard
Note: To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB 2.0 header
(9-pin USB45)
(see p.7 item 13)
Infrared module connector
(5-pin IR1)
(see p.7 item 18)
Internal audio connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.7 item 27)
(AUX1: see p.7 item 26)
Figure
FLOPPY1
Pin1
Secondary IDE connector (Black)
(39-pin IDE2, see p.7 item 9)
80-Pin ATA 100 cable
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
IRTX
+5V
DUMMY
1
GND
IRRX
CD-L
GND
CD1
GND
CD-R
AUX-L
GND
AUX1
GND
AUX-R
Description
Red marking
IDE2
PIN1
connect the black end
to the IDE devices
ASRock I/O
two default USB 2.0 ports on
the rear panel. If the USB 2.0
ports on the rear panel are not
sufficient, you may use this
USB 2.0 header to attach two
additional USB 2.0 ports.
This connector supports an
optional wireless transmitting
and receiving infrared module.
These connectors allow you
to receive stereo audio input
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
TM
provides you