Related Manuals for ASROCK P4i45G
Summary of Contents for ASROCK P4i45G
-
Page 1: User Manual
P4i45G / P4i45GL P4i45GV / P4i45GE User Manual Version 1.0 Published February 2003 Copyright©2003 ASRock INC. All rights reserved. -
Page 2: Copyright Notice
(including damages for loss of profits, loss of business, loss of data, interruption of business and the like), even if ASRock has been advised of the possibility of such damages arising from any defect or error in the manual or product. -
Page 3: Table Of Contents
1.4 Motherboard Layout (P4i45GL) ........11 1.5 Motherboard Layout (P4i45GV) ........12 1.6 Motherboard Layout (P4i45GE) ........13 1.7 ASRock I/O (P4i45G / P4i45GL / P4i45GV / P4i45GE) 14 2 Installation ............15 2.1 Screw Holes ..............15 2.2 Pre-installation Precautions ........... 15 2.3 CPU Installation .............. -
Page 4: Introduction
Chapter 1 Introduction Thank you for purchasing ASRock P4i45G / P4i45GL / P4i45GV / P4i45GE motherboard, a reliable motherboard produced under ASRock’s consistently stringent quality control. It delivers excellent performance with robust design conforming to ASRock’s commitment to quality and endurance. -
Page 5: Specifications
PCI LAN: Speed: 802.3u (10/100 Ethernet), supports Wake-On-LAN Hardware Monitor: CPU temperature sensing (ASRock U-COP); CPU overheat shutdown to protect CPU life (ASRock U-COP) (see CAUTION 4); Chassis temperature sensing; Voltage monitoring: +12V, +5V, +3V, Vcore; CPU fan tachometer; Chassis fan tachometer PCI slots: 3 slots with PCI Specification 2.2... - Page 6 To improve heat dissipation, remember to spray thermal grease between the CPU and the heatsink when you install the PC system. 5. Do NOT plug a 3.3V AGP card in the AGP slot on P4i45G/P4i45GE motherboard! It may cause permanent damage! ®...
- Page 7 P4i45G, P4i45GL, and P4i45GE may be fine tuned to support higher CPU front side bus frequencies on certain condition. Please refer to the table below for the details. CPU FSB Configuration Note P4i45G 800 MHz 1. Set the “FSB” jumper to “TEST” mode (see page 18).
- Page 8 HYB250256800BT-6 SINGLE SIDE ELIXIR DDR266 ELIXIR N2DS12880AT-75B DOUBLE SIDE APACER DDR266 NANYA NT5DS16M8AT-7K SINGLE SIDE SAMSUNG DDR266 SAMSUNG K4H280838C-TCB0 SINGLE SIDE Since the memory types are changing rapidly, please visit ASRock website (http://www.asrock.com/support/index.htm) for the latest recommended memory support list.
- Page 9 HYB250256800BT-6 DOUBLE SIDE MICRON DDR400 MICRON MT46V16M8 DOUBLE SIDE MICRON DDR333 MICRON MT46V32M8 DOUBLE SIDE NANYA DDR333 NANYA NT5DS32M8AT-6 DOUBLE SIDE Since the memory types are changing rapidly, please visit ASRock website (http://www.asrock.com/support/index.htm) for the latest recommended memory support list.
-
Page 10: Motherboard Layout (P4I45G)
1.3 Motherboard Layout (P4i45G) 24.4cm (9.6 in) PS/2 PS2_USB_PWR1 Mouse PS/2 Keyboard USB01 USB23 Intel 845G Line out Chipset Line Line in Mic in AUX1 AGP 1 CMOS Battery AUDIO1 PCI 1 CLRCMOS0 Intel Audio CODEC ICH4 PCI 2 Super... -
Page 11: Motherboard Layout (P4I45Gl)
1.4 Motherboard Layout (P4i45GL) 24.4cm (9.6 in) PS/2 PS2_USB_PWR1 Mouse PS/2 Keyboard USB01 USB23 Intel 845GL Line out Chipset Line Line in Mic in AUX1 CMOS Battery AUDIO1 PCI 1 CLRCMOS0 Intel Audio CODEC ICH4 PCI 2 Super FLOPPY1 FLOPPY1 FLOPPY1 FLOPPY1 P4i45GL... -
Page 12: Motherboard Layout (P4I45Gv)
1.5 Motherboard Layout (P4i45GV) 24.4cm (9.6 in) PS/2 PS2_USB_PWR1 Mouse PS/2 Keyboard USB01 USB23 Intel 845GV Line out Chipset Line Line in Mic in AUX1 CMOS Battery AUDIO1 PCI 1 CLRCMOS0 Intel Audio CODEC ICH4 PCI 2 Super FLOPPY1 FLOPPY1 FLOPPY1 FLOPPY1 P4i45GV... -
Page 13: Motherboard Layout (P4I45Ge)
1.6 Motherboard Layout (P4i45GE) 24.4cm (9.6 in) PS/2 PS2_USB_PWR1 Mouse PS/2 Keyboard USB01 USB23 Intel 845GE Line out Chipset Line Line in Mic in AUX1 AGP 1 CMOS Battery AUDIO1 PCI 1 CLRCMOS0 Intel Audio CODEC ICH4 PCI 2 Super FLOPPY1 FLOPPY1 FLOPPY1... -
Page 14: Asrock I/O (P4I45G / P4I45Gl / P4I45Gv / P4I45Ge)
1.7 ASRock I/O (P4i45G / P4i45GL / P4i45GV / P4i45GE) Parallel Port Line Out (Lime) RJ-45 Port USB 2.0 Ports Game Port VGA Port Microphone (Pink) PS/2 Keyboard Port (Purple) Line In (Light Blue) PS/2 Mouse Port (Green) -
Page 15: Installation
Chapter 2 Installation P4i45G / P4i45GL / P4i45GV / P4i45GE is a Micro ATX form factor (9.6" x 9.6", 24.4 x 24.4 cm) motherboard. Before you install the motherboard, study the configuration of your chassis to ensure that the motherboard fits into it. -
Page 16: Installation Of Heatsink And Cpu Fan
SDRAM (Synchronous DRAM) DIMM (Dual In-line Memory Module) has 168 pins and DDR (Double Data Rate) SDRAM DIMM has 184 pins. There are two SDRAM DIMM slots (black) and two DDR DIMM slots (blue) provided on P4i45G, P4i45GL, and P4i45GV motherboards. On P4i45GE motherboard, only 2 DDR DIMM slots and NO SDRAM DIMM SLOTS are provided. -
Page 17: Expansion Slots
DIMM is properly seated. 2.6 Expansion Slots (PCI, AMR, and AGP Slots) There are 3 PCI slots and 1 AMR slot on P4i45G, P4i45GL, P4i45GV, and P4i45GE motherboards. Additionally, there is 1 AGP slot on P4i45G and P4i45GE. -
Page 18: Jumpers Setup
“NORMAL” (short pin1, pin2) is the default setting for the (see p.10 / p.13 item 28) NORMAL TEST FSB jumper. “TEST” (short (for P4i45G / P4i45GE pin2, pin3) is the setting for motherboard only) the over clocking of CPU frequency. PS2_USB_PWR1... -
Page 19: Connectors
Note: To optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black). USB_PWR USB header ASRock I/O already (9-pin USB45) provided 4 default USB ports DUMMY If the 4-USB ports on the rear (see p.10-p.13 item 13) - Page 20 Front panel audio connector This is an interface for front +5VA BACKOUT-R (9-pin AUDIO1) panel audio cable that allows BACKOUT-L convenient connection and (see p.10-p.13 item 20) control of audio devices. AUD-OUT-L DUMMY AUD-OUT-R MIC-POWER PLED+ System panel connector This connector accommo- PLED- PWRBTN# (9-pin PANEL1)
-
Page 21: Bios Setup
Chapter 3 BIOS Setup 3.1 BIOS Setup Utility This section explains how to configure your system using the BIOS Setup Utility. The BIOS FWH chip on the motherboard stores the BIOS Setup Utility. When you start up the computer, there is a chance for you to run the BIOS Setup. Press <F2> during the Power-On-Self-Test (POST) to enter the BIOS Setup Utility, otherwise, POST continues with its test routines. -
Page 22: Main Menu
20:07:40 Month: Jan - Dec Day: 01 - 31 Floppy Drives Year: 1980 - 2099 IDE Devices BIOS Version P4I45G BIOS P1.00 Processor Type Pentium (R) 4 Family CPU Processor Speed 2100 MHz Cache Size 512 KB Microcode Update F23 / 08... - Page 23 TYPE To set the type of the IDE device, first, please select “IDE Devices” on Main menu and press <Enter> to get into the sub-menu. Then, select among “Primary IDE Master”, “Primary IDE Slave”, “Secondary IDE Master”, and “Secondary IDE Slave” to make configuration of its type. After making your selections on this sub-menu, press <ESC>...
-
Page 24: Advanced, Security, Power, Boot, And Exit Menus
[CD/DVD]: This is used for IDE CD/DVD drives. [ARMD]: This is used for IDE ARMD (ATAPI Removable Media Device), such as MO. Cylinders This is used to configure the number of cylinders. Refer to the drive documentation to determine the correct value. Heads This is used to configure the number of read/write heads. -
Page 25: Software Support
To see this demo program, you can run Microsoft Media Player to play the file. 4.2.5 Contact Information If you need to contact ASRock or want to know more about ASRock, welcome to visit ASRock’s website: http://www.asrock.com; or you may contact your... -
Page 26: Appendix: Advanced Bios Setup
You can also select other value as operating frequency: [200MHz], [266MHz], [333MHz]. Hyper-Threading Technology (for P4i45G / P4i45GV / P4i45GE only): ® To enable this feature, it requires a computer system with an Intel Pentium processor at 3.06 GHz or higher and an operating system that includes... -
Page 27: Chipset Configuration
Chipset Configuration: AMIBIOS SETUP UTILITY - VERSION 3.31a Advanced Chipset Configuration [ Setup Help ] <Enter> to select the AGP Aperture Size 64MB size of mapped memory ICH Delayed Transaction Disabled for graphics data. USB Controller Enabled USB Device Legacy Support Disabled DRAM CAS Latency Auto... - Page 28 PCI Latency Timer (PCI Clocks): The default is 32. We recommend you to keep the default value unless your PCI expansion cards’ specifications require other settings. Primary Graphics Adapter: This allows you to select [Internal VGA], or [AGP], or [PCI] as the primary graphics adapter. Peripheral Configuration: AMIBIOS SETUP UTILITY - VERSION 3.31a Advanced...
-
Page 29: Security Setup Menu
OnBoard AC’97 Audio: Select whether to enable or disable the onboard AC’97 Audio feature. OnBoard MC’97 Modem: Select [Auto] or [Disabled] for the onboard MC’97 Modem feature. System Hardware Monitor: You can check the status of the hardware on your system. -
Page 30: Power Setup Menu
User Password: This field shows the status of the User Password. [Clear]: No password has been set. [Set]: User password has been set. Set Supervisor Password: Press <Enter> to set Supervisor Password. Valid password can be a 1 to 6 alphanumeric characters combination. If you already have a password, you must enter your current password first in order to create a new password. -
Page 31: Boot Setup Menu
Ring-In Power On: Use this to enable or disable Ring-in signals to turn on the system from the power-soft-off mode. PCI Devices Power On: Use this to enable or disable PCI devices to turn on the system from the power-soft-off mode. PS/2 Keyboard Power On: Use this to enable or disable PS/2 keyboard to turn on the system from the power-soft-off mode. -
Page 32: Exit Menu
5. Exit Menu AMIBIOS SETUP UTILITY - VERSION 3.31a Exit Advanced Security Power Boot Main [ Setup Help ] [ Enter ] Exit Saving Changes [ Enter ] Exit Discarding Changes Exits and saves the [ Enter ] Load Default Settings changes in CMOS RAM.