How To Use The Magtek Scra Demo; Connecting Via Usb Otg - Magtek aDynamo Demo Manual

2 - How to use the MagTek SCRA Demo

2 How to use the MagTek SCRA Demo
This section describes how to use the MagTek SCRA Demo on an Android host. Some peripherals are
not included in every MagTek SCRA device, so use each feature of the Demo accordingly.
2.1

Connecting via USB OTG

This section describes how to use the MagTek SCRA Demo with a SCRA Device such as Dynamag,
DynaMAX, eDynamo, mDynamo, BulleT, uDynamo, tDynamo, and DynaWave, iDynamo 5 (Gen III)
connected to an Android host via USB OTG cable. Please note that the Android host must have USB
OTG support to use this connection type.
1) Connect the MagTek SCRA device to the Android host USB port using an OTG cable.
2) Press on MagTek SCRA Demo
3) Connect a SCRA Device via USB OTG cable, then select USB in the menu.
4) If the device is Serial with a USB OTG cable, press on the device selector to the right of USB, then
select .
Serial
5) Press on Connect .
aDynamo, uDynamo, Dynamag, DynaMAX, eDynamo, mDynamo, BulleT, tDynamo, DynaWave, iDynamo 5 (Gen III)| Secure Card Reader
Authenticator | MagTek SCRA Demo and OEM Demo Manual ( Android )
Page 7
to launch the app.