Table of Contents
Advertisement
DEFINITIONS FOR ILLUMINATED LED INDICATORS
Power
Wiring
Using
On
Battery
Fault
On
Off
Off
Set
Off
On/Off
On
Set
Off
On/Off
On
Set
Off
Off
On
Up
Off
On/Off
On/Off
Set
On/Off
On
On/Off
Set/Up
LIMITED WARRANTY AND POWER CONTROL GUARANTEE
In purchasing UP625/ UP825 in the United States or Canada, the original end user receives
a Limited Warranty and CyberPower's Power Control Guarantee from CyberPower Systems
(USA), Inc. (for ease of reading, referred to as "CyberPower"). The Limited Warranty and
the Power Control Guarantee are intended to be the initial end-user's exclusive rights and
remedies. The Limited Warranty and the Power Control Guarantee are separate, all though
they are related.
Limited Warranty. The original end user (referred to as the "Initial Customer") receives an
express limited warranty for the UP625 / UP 825 (referred to as the "Limited Warranty"),
purchased from CyberPower (referred to as the "Product"). The Limited Warranty is for the
Product itself. The terms of the Limited Warranty are explained below.
Power Control Guarantee. CyberPower also provides the Initial Customer with protection
in the event that the Product is not free from defects in materials and workmanship, and
certain equipment connected to the Product is damaged (the "Power Control Guarantee").
The Power Control Guarantee protects the Initial Customer for damage to equipment
plugged into the Product. The terms of the Power Control Guarantee are explained below.
The Limited Warranty and the Power Control Guarantee are subject to the terms set forth
Circuit
Breaker
Alarm
Off
Normal
Two
Utility Failure- The UPS is providing battery power
Beeps
to the Battery-Power Supplied outlets.
Utility Failure- The UPS is providing battery power.
Rapid
The rapid beeps indicate the battery will run out of
Beeps
charge within a few minutes.
Two
Overload- Occurs in the Full-time Surge Protection
beeps
Outlets. Turn the UPS off and unplug at least one
or
piece of equipment from the UPS.
rapid
seconds, reset the circuit breaker and turn the
beeps
UPS on.
Overload- Occurs in the Battery-power Supplied
Outlets. Turn the UPS off and unplug at least one
Long
piece of equipment from the UPS.
Beep
seconds, reset the circuit breaker and turn the
UPS on.
Electrical Wiring Fault- This indicates a wiring a
problem such as a bad ground, missed ground or
reversed wiring within the AC outlet.
None
advised to disconnect all electrical equipment from
the outlet and have the outlet checked by an
electrician.
8
Condition
Wait 5
Wait 5
User is
Advertisement
Table of Contents
