Table of Contents
Advertisement
DEFINITIONS FOR ILLUMINATED LED INDICATORS
Power
Using
Wiring
Circuit
On
Battery
Fault
Breaker
On
Off
Off
Off
On
On/Off
Off
On
On/Off
Off
On
Off
Off
On/Off
On/Off
On/Off
On/Off
On
Set/Up
Alarm
Set
Off
Normal
Two
Utility Failure- The UPS is providing battery power
Set
Beeps
to the Battery-Power Supplied outlets.
Utility Failure- The UPS is providing battery
Rapid
Set
power. The rapid beeps indicate the battery will
Beeps
run out of charge within a few minutes.
Two
Overload- Occurs in the Full-time Surge
beeps
Protection Outlets. Turn the UPS off and unplug
Up
or
at least one piece of equipment from the UPS.
rapid
Wait 5 seconds, reset the circuit breaker and turn
beeps
the UPS on.
Overload- Occurs in the Battery-power Supplied
Outlets. Turn the UPS off and unplug at least one
Long
Set
piece of equipment from the UPS.
Beep
seconds, reset the circuit breaker and turn the
UPS on.
Electrical Wiring Fault- This indicates a wiring a
problem such as a bad ground, missed ground or
reversed wiring within the AC outlet. User is
None
advised to disconnect all electrical equipment
from the outlet and have the outlet checked by an
electrician.
10
Condition
Wait 5
Advertisement
Table of Contents
