Digilin CALIBRE Installation Manual

CALIBRE - Linear Lighting Systems
Installation Guide
CAUTION
• Installation should only be performed by a qualified professional.
• Install in accordance with all appropriate wiring standards.
• DALI is not SELV and needs to be wired accordingly.
• Never connect a LED luminaire to a driver that is powered. Doing so may result in damage to the LED.
• Always make sure the output voltage range and output current of the LED driver match the requirements of the
LED luminaire. Failure to do so may result in damage to both the driver and the luminaire.
• The light source contained in this luminaire shall only be replaced by the manufacturer, specified service agent or
a similar qualified person.
• Do not install under mechanical stress.
• Allow for expansion due to changes in temperature.
• Please be aware that while the system has a very long operational life, faults may occur, and provision needs to
be made for maintenance.
• All cabling connections should be sealed and protected.
• Always turn off power before working on luminaire.
www.digilin.com.au
+617 3899 1267
ABN 76 634 301 376
Document Revision: 240514 - Installation Guide Calibre
Product specifications are subject to change without notice
1 of 5
©2023 Digilin Technologies