ASROCK ALIVENF6G-GLAN User Manual page 21

C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager.
For Windows
Click "Audio I/O", select "Connector Settings"
"Disable front panel jack detection", and save the change by
clicking "OK".
For Windows
Click the right-top "Folder" icon
panel jack detection", and save the change by clicking "OK".
System Panel Header
(9-pin PANEL1)
(see p.10 No. 17)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.10 No. 20)
Chassis Fan Connector
(3-pin CHA_FAN1)
CHA_FAN_SPEED
(see p.10 No. 14)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.10 No. 5)
FAN_SPEED_CONTROL
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
®
2000 / XP / XP 64-bit OS:
® Vista TM / Vista TM 64-bit OS:
, choose "Disable front
This header accommodates
PLED+
PLED-
PWRBTN#
several system front panel
GND
functions.
1
DUMMY
RESET#
GND
HDLED-
HDLED+
Please connect the chassis
1
speaker to this header.
SPEAKER
DUMMY
DUMMY
+5V
Please connect a chassis fan
cable to this connector and
+12V
match the black wire to the
GND
ground pin.
Please connect the CPU fan
4 3 2 1
cable to this connector and
GND
+12V
match the black wire to the
CPU_FAN_SPEED
ground pin.
Pin 1-3 Connected
3-Pin Fan Installation
2 1 2 1 2 1 2 1 2 1
, choose