Hardware Health Event Monitoring Screen - ASROCK AD410PV - V1.0 User Manual

3.5

3.5 Hardware Health Event Monitoring Screen

3.5 3.5 3.5 Hardware Health Event Monitoring Screen Hardware Health Event Monitoring Screen Hardware Health Event Monitoring Screen Hardware Health Event Monitoring Screen
In this section, it allows you to monitor the status of the hardware on your system,
including the parameters of the CPU temperature, motherboard temperature, CPU fan
speed, chassis fan speed, and the critical voltage.
Main OC Tweaker
Hardware Health Event Monitoring
CPU Temperature
M / B Temperature
CPU Fan Speed
Chassis Fan Speed
Vcore
+ 3.30V
+ 5.00V
+ 12.00V
CPU Quiet Fan
Chassis Fan Control
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
CPU Quiet Fan
This item allows you to identify the temperature of CPU fan. If you set this
option as [Disabled], the CPU fan will operate in full speed. If you set this
option as [Enabled], you will find the items "Target CPU Temperature" and
"Target Fan Speed" appear to allow you adjusting them. The default value
is [Disabled]. You are allowed to enable this function only when you install
4-pin CPU fan.
Target CPU Temperature
The target temperature will be between 45 C/113 F and 65 C/149 F.
The default value is [50 C/122 F].
Target Fan Speed
Use this option to set the target fan speed. You can freely adjust the
target fan speed according to the target CPU temperature that you
choose. Configuration options: [Level 1], [Level 2], [Level 3], [Level 4],
[Level 5], [Level 6] [Level 7], [Level 8] and [Level 9].
Chassis Fan Control
This item allows you to control the speed of chassis fan. Configuration
options: [Full Speed], [Level 1], [Level 2], [Level 3], [Level 4], [Level 5],
[Level 6] [Level 7], [Level 8] and [Level 9].
4 2 4 2 4 2
4 2 4 2
BIOS SETUP UTILITY
Advanced H/W Monitor Boot Security
Enable/Disable
CPU Quiet Fan
Function.
: 37 C / 98 F
: 31 C / 87 F
: 3400 RPM
: N / A
: 1.629V
: 3.306V
: 5.067V
: 11.890V
F1
[Disabled]
F9
F10
[Full Speed]
ESC
Exit
Select Screen
Select Item
General Help
Load Defaults
Save and Exit
Exit