Onboard Headers And Connectors - ASROCK 890FX DELUXE5 User Manual

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.12 No. 29)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.12 No. 17)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA3 Connectors
(SATA3_1_2: see p.12, No. 20)
(SATA3_3_4: see p.12, No. 19)
(SATA3_5_6: see p.12, No. 18)
(SATA3_7: see p.12, No. 31)
(SATA3_8: see p.12, No. 32)
SATA3_8 SATA3_7
Serial ATA (SATA)
Data Cable
(Optional)
FLOPPY1
Pin1
IDE1
PIN1
These eight Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate. If
you install the HDD on the
eSATA port on the rear I/O,
the internal SATA3_8 will not
function.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
2 7 2 7 2 7 2 7 2 7
the red-striped side to Pin1
connect the black end
to the IDE devices