Table of Contents
Advertisement
Transferring Bank Data to the Controller
Bank data stored on Memory Cards can be transferred to the current bank of the
specified channel.
RUN mode-MENU key-[BANK]-[CF
Setting value
File
CH
Important
The current settings of the Sensor Controller will be changed. However, if you turn the power
OFF without saving the settings, the settings will revert to the original settings before the bank
data was transferred. Save the current settings by saving them on the Sensor Controller of the
selected channel.
Note
Serial communication commands can be used to transfer bank data to Sensor Controllers.
BKMC2CTR command p.65
ZG2-DSU User's Manual
CONT]
Description
Selects the bank file number to transfer.
(BANK0 to 255)
Selects the channel of the Sensor Controller at the transfer
destination. (1, 2, default value: 1)
CH2 is not displayed when it is not connected.
Transferring Bank Data to the Controller
39
Advertisement
Table of Contents
