Configuration User Interface - Omron WS02-9094G - V1.0 Operation Manual

Generic Slave Device DTM
2-5-1

Configuration User Interface

Opening the
Configuration DTM
Configuration Tab
Device Settings
58
The configuration DTM is opened by
• Selecting the slave DTM entry in the Network view, and double-clicking
the left mouse button.
• Selecting the slave DTM in the Network view, and right-clicking the
mouse. From the context menu, select Configuration.
The slave DTM Configuration User Interface, which is displayed in the CX-
Profibus DTM view is shown below. The figure shows the user interface for an
OMRON CJ1W-PRT21 PROFIBUS DP Slave Unit. By default the Configura-
tion tab is opened.
In general, the Configuration User Interface for the Generic Slave Device
DTM, contains three tabs. Above these tabs the Device, the Manufacturer, the
GSD file and the Unit's PROFIBUS Ident number are displayed.
Note The three tabs allow the user to set the slave parameters and configure the
I/O for a standard PROFIBUS DP slave device. For slave devices which sup-
port the extension PROFIBUS DP-V1, to additional tabs will be displayed.
These tabs are discussed later.
The Configuration tab contains the Device settings and the I/O module config-
uration.
The Device Settings contain the device address, i.e. the Unit's PROFIBUS
address and the Watchdog time for the Unit. The device address is normally
set automatically by the Master DTM, when the slave DTM is added to its tree.
However, the user has the opportunity to change the address. The changed
address will be transferred to the Master DTM.
Section 2-5