Omron WS02-9094G - V1.0 Operation Manual page 146

Number Message
52 CX-Server could not be config-
ured
53 CX-Server could not be initialized
A-4 Error Messages - System
The table below lists the Error messages related to the System on which the DTM is installed.
Number Message
100 Connected device can not be con-
figured with this DTM
101 Incorrect version of CX-Server.
102 [Name of the function] called with
improper parameters
103 Received XML Document does
not fit it's XML schema
104 Ole Register Drop Target Failed
105 Undefined control type
106 Communication failure with the
DTM
107 GUI could not be closed
Description
Configuration of CX-Server failed.
Initialization of CX-Server was not
possible.
Description
Incorrect firmware type.
Incorrect version of CX-Server.
Container called a function with
NULL pointer.
Container called a function with an
improper XML document.
An internal error has occurred.
An internal error has occurred.
An internal error has occurred.
An internal error has occurred.
Appendix
Correction
• Make sure the settings within the
Device Set-up tab are correct.
Select the Test Button to check
this.
• Make sure the Personal Com-
puter COM port selected within
the Device Set-up Configuration
is not in use by another applica-
tion. If it is close the connection
from within the other application.
• Restart CX-PROFIBUS.
• Restart Personal Computer to
ensure COM port is released.
• Ensure the correct version of CX-
Server is installed on the Personal
Computer. Refer to the Master
Manual for installation details.
When the problem has been
removed, perform one of the fol-
lowing successfully to confirm the
problem has been solved:
* Select the Configure Button in
the Device Set-up tab
* Select the Test Button in the
Device Set-up tab
• Ensure the correct version of CX-
Server is installed on the Personal
Computer. Refer to the Master
Manual for installation details.
Correction
Make sure the unit connected is a
CS1W-PRM21 or CJ1W-PRM21.
Make sure the Unit number in the
Device set-up corresponds to the
physical unit.
Make sure the correct CX-Server
version is installed. Version must be
1.7 and up.
There must be problem in the con-
tainer. Reinstall CX-PROFIBUS, if
problem persists contact supplier.
There must be a problem in con-
tainer program. Reinstall CX-PROFI-
BUS, if problem persists contact
supplier.
Reinstall CX-PROFIBUS, if problem
persists contact supplier.
Reinstall CX-PROFIBUS, if problem
persists contact supplier.
Reinstall CX-PROFIBUS, if problem
persists contact supplier.
Reinstall CX-PROFIBUS, if problem
persists contact supplier.
131