Omron V400-H201 User Manual page 26

Section 2
Installation and Connections
Disconnecting the Cable from the Handheld 2D Code
Reader
1.
Disconnect the cable connector from the host device.
p.25
2.
Open the cover.
Press down on the indentations on both sides of the cover
as you open it.
Do not apply excessive force to the cover.
3.
Disconnect the cable.
Grasp the coupling (part B) on the plug and pull the plug
out straight as shown in the diagram below.
Cable
4.
Close the cover.
Keep fingers clear when closing the case to pre-
vent the case closing on them.
V400-H101/201
24
User's Manual
Coupling
B