Omron NT21 - SETUP MANUAL 10-2001 Setup Manual page 68

Connecting to the RS-232C Port at the Host
When using the peripheral port of a CS1G/H, CS1G/H-H, or CJ1G
Word Value
CIO 144 8200
CIO 145 0000 to 0009
CIO 150 000j
*1 Set any value between 0000 and 0009 Hex for the communications baud rate.
The same baud rate will be used regardless of the value as long as it is between
0000 and 0009 Hex.
When connecting PTs with model numbers 0 and 2 to 5 to the built-in RS-232C
port, for example, set CIO 160 to 8200 Hex, CIO 161 to 0000 Hex and set
CIO166 to 0005 Hex.
Either set PC Setup directly from a Programming Device (Programming Con-
sole), or transmit the PC Setup made at a Programming Device (CX-Program-
mer) to the CPU Unit. For details on PC Setup,refer to the SYSMAC CS Series
Operation Manual (W339-E1-j) or SYSMAC CJ Series Operation Manual
(W393-E1-j).
Settings
1:N NT Link mode
(*1)
Communications baud rate (standard)
j = The largest model number of the
connected PT (0 – 7)
Section 4-1
57