Omron NT21 - SETUP MANUAL 10-2001 Setup Manual page 133

Operations in the System Installer Mode
122
Clear the screen data by following the menu operation from the System Installer
mode menu shown below.
Select Erase Screen Data.
Select Yes.
The screen data is cleared. During clear-
ance, the message Erasing ... is displayed.
• If Return to Menu is selected, the NT21 returns to the MEMORY INIT. MENU
screen without clearing the screen data.
• If screen data clearance fails, a screen asking if you wish to try again is dis-
played.
On completion of screen data clearance, the NT21 returns to the System Install-
er mode menu screen.
After the screen data has been cleared, if an attempt is made to set the NT21 to
the RUN mode before screen data has been transmitted from the NT Support
Tool or Memory Unit, an error message will be displayed and the RUN mode will
not be established.
Section 6-5