Omron NT21 - SETUP MANUAL 10-2001 Setup Manual page 135

Transmitting the Screen Data
Precautions to Be
Observed When
Transmitting Screen Data
124
3. Establish the Transmit mode by following the menu operation from the Sys-
tem Menu shown below at the NT21.
4. Open the screen data to be transmitted at the NT Support Tool, then select
Download (NTST PT) in the NT Support Tool's Connect menu and specify
the data to be transmitted.
5. During screen data transmission, the transmission status is displayed.
6. On completion of screen data transmission, press the Quit touch switch.
The NT21 returns to the Transmit mode.
If the screen data cannot be successfully transmitted from the NT Support Tool,
use the communication check functions of the NT21 to check if communication
between the NT21 is normal or not (page 161).
If any of the following, or a system error, occurs during transmission of screen
data, the transmitted screen data will not be registered correctly in the NT21. If
this happens, the NT21 may not enter the RUN mode when started up, or there
may be unpredictable malfunctions such as failure to display screens during op-
eration. In this case, the screen data must be retransmitted in file units to register
it correctly.
• The power to the NT21 is interrupted.
• The power to the personal computer on which the NT Support Tool is running is
interrupted or the computer is reset.
• The cable connecting the NT21 to the personal computer on which the NT
Support Tool is running is disconnected or has a broken wire.
• The Quit touch switch on the NT21 screen is pressed to end screen data trans-
mission.
Section
Select Transmit Mode.
Select Tool Transmit.
6-6