Omron NQ HMI Getting Started Manual page 42

Using NQ-Designer
4-2-2-5 Alarms
28
Register Tag name
s0033 Start data
through enter key
s0035 Ignore real and historical
alarms
s0036 Run LED on/off
s0037 Allow USB host operation Read/Write
Nodes
The Nodes folder contains the information of your network: the name of the
panel and PLCs, node addresses in the network (listed under COM1 or
COM2), protocol used on the COM port. COM1 and COM2 can have different
protocols.
In this folder you can also add a node to your network.
• Click Nodes ( ).
• Right-Click on screen.
• Select add Node.
In the alarm folder alarms can be assigned and configured.
For alarms there can be chosen of two formats to configure.
• 16 Random words
For each TAG (word) 16 alarms can be configured / assigned in the alarm
folder.
A total of 16 different words ( = 256 alarms) can be configured / assigned.
• 16 consecutive words
This function is enabled after 16 consecutive Word tags have been created
in the tag database. If this method is chosen all 256 lines will be created in
your alarm screen.
Read/Write
entry only Read/Write
Read/Write
Read/Write
Section 4-2
Description
User can choose the
mode of data entry
using this bit.
0: allow data entry
through enter key or
numeric key
1: allow data entry only
by pressing enter key
first
0: Monitor all alarms
1: Ignore all real and
historical alarms
0: Run Led is On
1: Run Led is Off
0: USB host operation
not allowed
1: USB host operation
allowed.