Omron NQ HMI Getting Started Manual page 87

NQ-Series diagnostics
Table 7.3: System set-up settings
Setting
TouchScreen Calibrate
Brightness Control
Contrast Control
RTC Settings
Com Port Settings
ScreenSaver Time
Application Erase
Firmware Erase
Beeper Setting
Battery Status
Clear retentive registers
System Information
Pressing the buttons on one of the 2 set-up screens will take you to the
specific set-up procedures for the specific settings.
Description
To calibrate the touch screen. Refer also to 7-2 Touch
screen calibration.
To set the brightness of the screen.
To set the constrast of the screen (NQ5)
To set the RTC.
To set the com port.
To set the screensaver time.
To erase the application. Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
To erase the firmware. Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
To set the beeper.
To view the battery status.
To clear all retentive registers.
To view the system information.
Section 7-4
73