Omron NQ HMI Getting Started Manual page 33

Preparing for programming
4-1-2-2 Microsoft® Windows® Vista configuration
4-1-3 Installing the software
4-1-4 Connecting the NQ-Series power supply
4-1-5 Connecting the NQ-Series to a PC
4-1-5-1 Serial cable
Device
Display
Serial Port
Mouse
Keyboard
/i
Table 4.2: Windows Vista configuration
Device
Processor
Operating System
System RAM
Hard Disk Space
Display
Serial Port
Mouse
Keyboard
To install NQ-Designer run setup.exe from the installation disc and follow the
installation instructions.
Connect a 24 V power supply to the NQ-Series.
DC
The NQ-Series can be connected to a PC with the following programming
cables:
• Serial cable (NT2S-CN002)
• USB cable (CP1W-CN221)
Refer to Appendix A-2 and A-4 for more information on cables.
The serial cable can be used directly after connecting the cable.
Recommendations
Minimum: 800 x 600 with 256 colours
Recommended: 1024 x 768 with 16 bit colour quality
Serial port or USB port
Microsoft® Mouse or compatible pointing device
Required
Recommendations
Minimum: 800 MHz Pentium processor or
equivalent processor
Recommended: 1 GHz Pentium processor or
equivalent processor
Microsoft® Windows® Vista Home
Microsoft® Windows® Vista Business Edition
Minimum: 512 MB
Recommended: 1 GB
800 MB
(including 200 MB for the .NET Framework Redistributable)
Minimum: 800 x 600 with 256 colours
Recommended: 1024 x 768 with 16 bit colour quality
Serial port or USB port
Microsoft® Mouse or compatible pointing device
Required
Section 4-1
19