Thank you for choosing a 4.2 Installing and Changing the Fluidbottle MOKE ACTORY DEVICE 4.3 Fogfluid 4.4 Power Connection of the Tourhazer II-E The S product range offers 5 Operating Instructions MOKE ACTORY you a vast variety of complete solutions, 5.1 Turning the device on...
Failure to properly follow these instructions may lead to a fire, explosion or electrical shock. Type: Tourhazer II-E Type: Tourhazer II Factory Fan Scotty II Captain D Data II Captain D Case Enterprise TC4...
No case has so far been reported in which a human being has been harmed because of using our device to produce artificial fog. However, this can only be guaranteed if the professional fog generators are used accordingly, i.e. at the correct vaporization temperatures as well as with the correctly mixed original Smoke Factory fog fluid. WARNING! People with health problems or problems of the respiratory tract or with an inclination for allergies should avoid any contact with artificially-made fog.
SMOKE FACTORY-fog generator. Scotty II or Fan Fogger? It doesn’t matter. You get the equipment that makes the difference. Fig. 1:Tourhazer II-E – Front View 6: Mains supply Control panel for adjusting the DMX start address Fluid tube inlet...
Page 7
3: Safety guard (air inlet – must always be open) 4: Air deflector (adjustable) 5: Connection area: Power, Controls, Medium 6: Canister compartment 7: Fluid can Fig. 2:Tourhazer II-E - Isometric View Pin-Configuration: See page 11 Fig. 3:Tourhazer II-E - Isometric View Canisterclosing with integrated sinter-filter...
A „P“ and two figures appear on the LED display (for instance P 15). After approximately 60 sec. the Tourhazer II-E is heated up and ready to be used. Press the Enter-button once (14) to start hazing. After a short interruption the hazing will begin.
The performance of the fog generator can easily be adjusted between 1 % and 99%. 5.1 Turning the device on Connect the Tourhazer II-E to the power socket (make sure the fluid canister is connected to the Tourhazer II-E) , the display shows Fig.: 6: Screen After aprox.
Please ensure that the Tour Hazer II-E is not disconnected from the power supply too early. Otherwise the tubes and HE cannot be cleaned properly. After the cleaning process is completed the Tourhazer II-E automatically turns into standby mode. Fig. 11: Standby Control System 5.3.1 External Control...
1% to 99%. 5.3.3 Stand alone Control The Smoke Factory – Hazer II-E can be used in the standalone mode. In this mode all data for the pump and the fan must be adjusted directly at the machine.
The Tourhazer II-E has two 2 Timer Program Modes: loop program mode and sequence program mode. The difference between these two modes is that the loop mode plays it´s program in a endless loop and the sequence mode is a timeline program with a specified stop time where the Tourhazer II-E stops working.
5.3.4.2 Sequence Program Mode Press the Enter Press the Mode button. button until “Program “Timer Program” Sequence“ appears appears Fig. 27: Timer Fig. 28: Sequence Press the Mode “Pump Button. Press the Enter Sequence A” Button. „Pause appears Pre-Runtime” select via the up appears, select down with the up and...
Press the Mode Button, the display shows Press the enter „Runtime button to start Sequence B” „Sequence select via the Up and Down Mode” Buttons the Runtime of Sequence B Fig. 35: Rin Time B from 0-99min Fig. 36: Start Press the Mode Button, the display shows...
Check fluid tube, disconnect and reconnect Fluid tube bent down or defect? Liquid into the air pump If Liquid runs to the air pump the Tourhazer II-E will automatically stop operating It’s necessary to send the Tour-Hazer for service...
5°C to +45 °C Dimensions (WxHxL) 533 mm x 248 mm x 442 mm Weight w/o fluid Approximately 18 kg Accessories Radio remote and cable remote control Scope of delivery Tourhazer II-E, instruction manual, canister lid for 5 litre can, power connection...
9. Warranty Conditions Effective only for the Federal Republic of Germany grants you warranty for the “Tourhazer II-E“ according to the following conditions MOKE ACTORY Free of charge, subject to the following conditions (No. 2 - 6) we will repair any defect or fault in the unit if it is caused by a proven factory fault and has been advised immediately after appearance and within 6 months of delivery to the end user.
10. Contact See the Performance We advise you We help you We provide you with information material fast und reliably Service and Contact Fog, Smoke & Haze Factory GmbH Licenced Importer Walsroder Str. 159 A D-30853 Langenhagen/Hannover B&K Braun Gmbh Industriestr.
Need help?
Do you have a question about the Tourhazer II-E and is the answer not in the manual?
Questions and answers