Offsetting the Control Output's ON Timing (4 and 8-channel Models)
4-11 Offsetting the Control Output's ON Timing (4 and 8-
channel Models)
Disabled (No Offset)
ch1
ch2
ch3
ch4
Note
Channel
Slope
325.0
Offset
15.0
Control variable
80.0
Control variable (%)
80.0
60.0
40.0
20.0
ch1
ch2
Offset Control can be set to adjust the time when each channel's control out-
put goes ON in order to reduce overlapping ON states. Offset Control is
enabled by default.
Variable type
Parameter name
81/C1
Offset control
The ON timing will overlap
(1) The waveforms are current waveforms of the SSR load power supply volt-
age.
(2) The amount of overlapping depends on the control variables and the tim-
ing of control variable changes.
1
2
3
100.0
175.0
0.0
5.0
20.0
40.0
ch3
ch4
Setting range
0: Disabled
1: Enabled
Section 4-11
4
250.0
10.0
60.0
Default
1 (Enabled)
51