Function Menu - Omron F400 Datasheet

Nomenclature:
(2) Ground terminal
(1)Power
indicator
(9)ERROR indicator
(10)RUN indicator
(11) RS-232C connector

Function menu

Measurement method
Five measurement modes are available. Selections will vary depending on the selected scene mode.
Common to both color extraction and color filter mode.
Search
Select this mode when you wish to focus the inspection on the
shape of the object. An image pattern (called a "model") is
stored, and measurement is performed using that pattern.
The degree of matching with the model (correlation value) and
the position where the model was found can be obtained.
Edge
Select this mode when you wish to know the coordinates of
the edge of the object. The width of the object can also be ob-
tained by subtracting the coordinates of one edge from the
other using a computation equation.
Area and center of gravity
Select this mode if you wish to obtain the size (called the "ar-
ea") and the position (called the "center of gravity") of the ob-
ject.
Center of gravity and main axis angle
Select this mode when you wish to obtain the tilt (called the
"main axis angle) of the object, in addition to the area and po-
sition. A longer processing time is required to obtain the main
axis angle. If you only wish to obtain the area and center of
gravity, select "Center of gravity and main axis angle".
F400
(4) Output terminals
(3) Power supply
(5) Input terminals
terminals
(4) Output terminals
(8) Camera connector
(1) Lit while power is ON.
(2) Connects to the ground wire.
(3) Connects to the power supply.
(4)
(5)
(6) Monitor
connector
(6) Connects to the monitor.
(7) Console (7) Connects to the console.
connector
(8) Connects to the camera.
(9) Lit when an error has occurred.
(10) Lit while the F400 is in Run
(11)Connects the F400 to external
* Please do not open here.
Color filter mode only
Dirt and damage
Select this mode if you wish to inspect for damage and dirt on
the measurement object. Places with large darkness devia-
tions are detected as defective.
Connects to the F400 to external
devices such as synchronous
sensors or programmable
controllers.
Mode.
devices such as personal
computers or programmable
controllers.
C-31